French Car Forum

Does anyone know anything about these?

Peter

help

ive got a xsara picasso 07 1.6 16v and its got some serious problens

runs from cold for aprox 30 mins then kangaroos and then acts like its out of fuel. switch off re start and works for 20/30 mins

its had map lambda temp injectors

error p2191 error

just fitted a new fuel pump relay and the car went nuts...

i had keys in my pocket...

Hello,
I have the Actia PAS XS Evolution diag box...it is the 9780.Z5 version....(Genuine...made in France?)
The disc that came with it is no longer downloading on my laptop...(Windows 10)
I was thinking about buying a new (later version) disc..... this version has no issues with windows 10.
Before I bought it I wondered if anyone knows if this is...

Hello everybody. I need help if possible. I want to buy an OBD reader system for my citroen C5 tourer 1.6 110cv 2009 but I don't know which system is the best. I've read a lot of information, software versions, lexia, diagbox...etc. There are different prices on the internet. Aliexpress, ebay.... there are so many that I don't know which one will...

I've just bought an early 2013 Pug Partner and want to activate the Cruise Control. I have an older version of Lexia that works fine on my M59 Berlingo, but am guessing that PP2000 will not work so I'll have to use Diagbox.
I've tried Diagbox 5.29 but get a lot of 'ECU Not Recognised' messages when doing an error scan so am guessing that 5.29 is...

Hi.How i can know is my egr valve good or bad?Here are shots from diagbox.
Car is going

Car idling

Hi,
I have a Citroen Xsara Picasso 2004 - Heater Blower Resistor wiring loom.
My heater stop blowing completely, so check I had power to the blowing motor and also the motor worked when power was applied, all good.
However when I checked the Heater Blower Resistor the connection was burnt where it connects to the connector on the wiring loom.
Not...

hi there.
i have Xantia x2 with xu10jr-rfv engine and Bosch mp5.2 ECU. there is no CPH.
i bought DigBox lexia3/pp2000 and installed on win7 32bit. updated to 7.57v
the lexia 3 can show ABS and AirBag faults and test them
but cant connect to ECU for engine diagnose test. this is the erorr (picture1):
the problem is from ECU or DiagBox ?

Can someone please help me? I have this very strange problem with my Peugeot 307 CC 2004.
The problem is that the sensor in my door handle only works sometimes and sometimes only after I have disconnected it for a while and then it works for just a couple of hours and then it's off again....
I have tried two different handles I have tried two...

Hi All,

It’s my first time here on this forum. Electric parking brake fault appeared on my Citroen C4 GP 2016 model and stayed for several days. Initially it was intermittent and then became constant fault when you open doors etc. can’t apply parking brakes at all now. After a few investigations and reading through these forums I figured that...

Hello guys i buyed a C4 picasso 1.6 hdi and conected it to delphi and got som faultcodes and wonder what part of things i shall put focus on for geting back the Power for the car ?

the speed is slow like 85-115km/h and the axeleration is superslow

i have tried to do a dpp cleaning ...

the codes i have is:

P1394

P1351

P0299

P0473

P0470...

Have just installed v7.01 on an xp laptop ...
1....my xsara picasso is not on list of vehicles

2...when I clicked xsara I got...erruer de chargement de cellule......what does that mean and what do I need to do?????
Will appreciate some help. It's all a bit baffling..

Bit of a strange one folks.
On a 4 poster, I lift the xantia up and pull it down, at the bottom of travel there is a knocking/popping sound which is quite distinct and audible. My mechanic said it could be felt through the sphere when touched. It can be heard and felt when driving, almost like a drop link type sound but its at the rear of the car...

Hey guys, long time lurker here. After refueling a few days ago I got the general check engine light on the screen of my 308 T9. It was diagnosed as a faulty additive pump and basically no garage wants to touch it since pairing a new one is a dealer only job, in their words. Dealer quote exceeds a 1000 euros which I find insane. By some googling I...

Hello.

My C5 2003 1.8 Petrol Automatic drives normally without issues but after being serviced at the dealer, I got the Service light and the Check Engine light.

In order to have an idea, I bought an ELM adapter and installed the FAP App, scan codes and received one code P0411 , after some search I found Secondary Air System , so, dismantled the...

Fault Code 1AA0H/6816 REFER TO OEM REPAIR INFORMATION

Hi,

I'm running Diagbox 7.57 in a Windows 7 VM via VirtualBox with a Lexia Rev C interface and USB passthrough. What I find is that I can't diagnose non-starting issues as it only records data up to the point when I crank the engine - as soon as I turn the key, Diagbox complains of losing the connection and asks me to retry or cancel. Likewise,...

Hi I have a fault code P0423 Atomizer for injection of fuel at the exhaust. It showed up today after changing the air intake temperature sensor. My Van has been having a strange problem like a diesel knocking noise but it only occurs when the air temperature is cold ie below 12c. This week has been good to me as the problem had been fine for...

Hello. I'm new here
Recently I bought the token form the PSA service box to using the diagbox. I've got a 2021 C5X witch I think they haven't starting selling in Europe yet I think.

The problem is the latest version of the diagbox (v9.119) doesn't have C5X in the list , automatically detect can read the VIN but says have no permission to...

Hello guys I jumped in my dispatch after it's been stood 2 weeks no crank and I couldn't even connect with my little El cheapo reader that has always connected.
I've got no heater blower no main lights just side lights.
I've tried resetting bsi main lights worked but still no crank and anti pollution on dash cowling for my efforts lol.
Reset...

Hi

Car spec : Citroen C5 X7 2009, 2.0 HDI 140 PS, vin: VF7**************[VIN obfuscated, can be read by forum staff]
This topic has started 2 years ago, with no visible starting point - and it's related with standard error that comes to main screen - anti pollution faulty. I know that there are a lot of similiar topics, but they are considered as one error - one problem. I think that my...

Have diagbox working on a. Chrome book?!

They are so oooo reliable and have no moving parts.

Hello friends, I'm looking for someone from Felixstowe / Ipswich or near with diagbox / lexia who can help me please.
Thank you so much.

I'm still having lexia/diagbox install fun and games.

I got another Windows xp with home edition on it.. Started installing diagbox and it stopped half ways through with a fail to install..

I'm not stuck with a half copy of diagbox but cannot find the dB cleaner anywhere to get rid it all.. I tried dooing an xp pro install but the cd drive...

Hi just installed the lexia software I found on here for my Citroen C4 Picasso.When I plug my actia in the light flashes 3 times then stays on.but my laptop says connected usb device not working.Any ideas

Has anyone here tried FAPlite -android software? Any recommendations on (preferably slim and cheap) bluetooth dongle that works with it?

all, I seem to have broken the access to my Pug diagrams, I am hopeless with Computers :)

It seems the system I bought loads a virtual machine running win XP in it's own window, as an admin, and fires up the documents.. but somehow I have made a change to login, and now cant get back to where I was.
The machine opens as a guest and then doesn't...

Hello,

I get the p0087 code on cold start (after about a min of ideling), car starts studdering (revs dial rotates 100-200 revs up/down) ... High pressure petrol value in this case is low (obd measure). If i shut down and restart car comes back and high pressure stables at around 50bar on idle.

So...am i doomed = faulty high pressure fuel pump?...

I would like to fit a towbar and associated wiring to my 2004 Berlingo.

What is the easiest way I can determine for sure if I have a canbus system?

Thank you

My go to site for OBD info

Dear all ,
Can any one help or has this fault come up .
I scan my car and this code come up p15A4 is c4 grand picasso 2016

Hi everybody. I bought a Citroen Xsara 2 1,6 16v 2002 with light and rain SENSOR. When i bought it 4 years ago, it had problems with lights so i changed the COM2000. After that lights works right. My problem is the wipers never worked fine. I can't tell if it was like this since i bought it, if it was before i changed the COM2000, i think so, but...

Earlier this year I bought a full chip reader from easydiagnostics. For several reasons I've not been ablo to use it until now.
2 discs followed the unit.
First disc with software and update worked fine (well, not tested in car yet, but software starts fine and I can click into car models without fault messages.).
To update further gives the...

Hi.

My Citroen C4 1.6 HDI 2007 aut. recently started having a total electrical meltdown. Mechanically the car runs well – it’s all electrical. When I start the car, following faults appear:
- ABS faulty
- Speed control faulty
- Service light
- STOP light
- A-bags/s-belts faulty
- Braking system faulty
- ESP faulty
- Wipers and light turn on...

Hello everyone,
Patient here is 1998 1.6l 8V Peugeot 306
VIN  VF3**************[VIN obfuscated, can be read by forum staff]
DAM 7980
The problem is that I'm unable to interface with my 306 using ACTIA cable and PP2000/Diagbox  (which launches PP2000).
I have a virtual machine with Win XP and 25.01 version of PP2000, and a Win7 one with Diagbox 9.91.

I have a VCI that looks like this: ...

Hello everyone,

I have just fitted the two recommended Borg Warner solenoid valves to the AL4 automatic transmission in my 2003 Citroën C3 following a fluid pressure problem. The official Citroën workshop manual says that a software update must now be carried out and this is indeed listed in my Lexia 3 diagnostic computer. When I try to do it, I...

So i got the DiagBox 9.91 (on VM) and have an OBD Bluetooth plug. is there a way to connect them instead of buying the physical VCI?
Car is 3008 2019

Hi all, is there anyone near Uttoxeter Burton Lichfield areas, with a code reader pls?
I have a 307 petrol engine car with a pollution fault. Need a clue what I need to do. No engine issues, runs just fine, but not sure it will pass an mot like this? I do know someone fitted a noisy exhaust though!
Cheers
Steve

What is Peugeot Planet ?
Its a piece of diagnostic equipment designed just for Peugeot vehicles.
Why is Peugeot Planet better than other code readers?

Peugeot Planet can do so much more, besides giving detailed information on some fault codes which may relate only to Peugeots, it can read live data of all the major components of the car and even...

i have a so far unsolvable problem with a Citroen C5 2001 2.0 sx (petrol)

the cars body always starts to vibrate at high speed(highway), as well as the steeringwheel.

at low speed(in town) the vibration happens randomly, usually when parking (especially when i have to make some adjusting) or at red traffic light while the engine is idle, or...

Hi,

Cambelt 'slipped' on this car. Long story short, garage agreed to fix, paying most of bill. Looked, on face of it, as though it would need new valves, at very least, and possibly pistons. However, car was returned with new camshaft, rockers, and water pump.

Engine feels like it has less pull than before cambelt failure. Car drives 'okay' but...

Thanks for adding me.
I have a strange issue with a Citroen Nemo 1.3 diesel, manual gearbox 2010 on a 60 plate.
The van has been starting and driving fine until 2 days ago when it will no longer start, EML is on and click flashes fast 🤷

So here is what happens.
Put the key in and all dash lights are fine, turn the key and dead (battery fine) as...

Is there anybody near Ellesmere Port that would be able to run a check on a bsi module please??

I have v7.83 (and earlier version) on disk as part of the kit from ALiExpress Fully C chip.

When i tried yesterday to connect, it connected but could not contact the ECU ? otehr options weer avaiable

So question is what version do i need to see the ECU on a 2015 (65 plate) C4 hatchback

Thanks

Hi.

Was driving up motorway yesterday at a steady 70mph and the car suddenly dropped into limp mode.
After approx 1 minute (if even) the car returned to full power and journey onwards was uneventful.

I've just taken the lexia to the car to see what happened and I'm guessing that it is the fuel pump. But as there are a lot of gubbins in the fuel...

hello, did anyone get Lexia running on a WIN10 computer?

a seller I converted with claims it will run as is on a WIN10 computer

thanks in advance..

Hi all,

I've just purchased a 15 plate Peugeot Expert Tepee and am looking to buy some diagnostic kit for it, however, on Aliexpress I see two versions - the older multi cable grey box or the new lime green single cable box, which would you recommend? Below are the titles from each product on Ali, I haven't put links as I'm not sure if that is...

I've not having much joy trying to find Diagbox locally through the Peugeot Google map of owners.. can anyone give me a lead for someone still in the area? It's for a 2006 M59 DV6ATED4 - I want to turn the seatbelt buzzer off! thanks J.

Where is the height adjustment setting in the suspension ecu?

My ecu is suspension ecotec

Hello All,

My (until very recently) very reliable hdi 110 Xantia will not start. Engine cranks, fuel pump whirrs (it is a new one) but there is no communication with the cph. The summarised back story is: the Xantia has not been running well recently, and I was just short of replacing the EGR. To test the EGR theory I connected the vac pump to...