French Car Forum

This might help:

I'm assumung pins 8 and 9 are the high current terminals.

If you buy a cheap Lexia 3 DiagBox on Ebay (Chinese copy?) expect problems in dealing with nasty badly produced software
and video's. Could have been the CD I got and others are better?
I was not sure in buying this if it was an illegal transaction? I spent many hours trying to figure out how to reconfigure their bad software.
Unless you are savvy...

AFAIK, causes can be broken wire/connector, damaged, obstructed or misaligned reluctor ring or sensor (all of which you have x4) or as your local garage opined, the rather expensive ECU, it's wiring and fuse(s).

These aftermarket ones probably won't be able to do as much as the Lexia - more importantly the software (Diagbox, that contains PP2000, Lexia and of course Diagbox itself) have embedded procedures for undertaking some functions that won't be available on other systems.

I and many other members have bought our kits from Easydiagnostics. There is...

Normally a 1/4 turn on the longest side.

Dont forget to pack your new bearings completely full of marine grease (also sold as "propshaft grease") its specifically designed to withstand moisture even submerged in salt water. It will prolong the life of the bearings significantly compare to the original grease that I suspect it's designed to NOT keep the bearings alive for much...

The Rover, nice car but I seemed to spend my life welding it up. Lunar Grey was my favourite colour and I always fancied a 3.5. The 2000 had to go when my work sent me abroad.

cachaciero

Flickr! should be OK, just a few hoops to jump through.

Moved to a better place...

It does sound like a failure of the stalk unit (most likely the ribbon cable) - it's not in this case a COM2000 though, it's a later one, possibly a COM2005, and I don't think the Bradford guy can repair those. Be prepared for a shock at the price :shock: Post up the last 8 digits of the VIN and we can find a part no...

hi and welcome

have you tried

as they are cit/pug specialist dismantlers,

or this breakers yard as they are very helpful and cheap

G.M Woodgate & SON
High Halden
TN26 3HX
01233 850303

or if you send me the last 8 digits of your chassis/VIN No. i will get you the OE price and part No.,
then if you dont like the dealers price you can do...

Ay up!

I can't see the piccies at all!

Photo bucket which hosts the images probably was having problems again.

cheers for this just signed up and thankfully nothing needed for her so I can guess anything that was needed has been done

I bought tyres from Blackcircles, not having heard of this nonsense, the place where they fitted the tyres couldn't balance them.
Quick phone call to Blackcircles, they arranged for Protyres in Portsmouth to balance the wheels at no cost to me.

The hardest part is getting the gap right between the front and rear doors and
a wooden wedge leaves your hands free to do this, if your way worked out for you thats great,

There's a nice diagram of the steering column showing the universal joint which occaisionally needs attention on page 2, as well. :)

PS The forum clock is still on winter time. :D

As James says...

And...

hmmm.. maybe I think too much (or worry too much) but...

When you open it you'll hear a rushing sound as the system depressurises and LHM rushes back to the reservoir.

doesn't that mean the suspension will drop to low position?

No, because you are already on low if you followed the instructions ;)
And if the car...