French Car Forum

Hi all,

I have tried and tried...honest! but have admitted defeat and i'm asking for help :)
Basically,i bought a clone from ebay and up to now i have got it to read most ecus on the car but the error code i need to clear is in an ecu that it just wont 'see' for some reason.
I've got an 'Antipollution Fault' message and as the car has already...

Hi Guys.

I've owned my ZX for 3 months now, and have a few questions regarding mechanicals:

HANDBRAKE - Try as I might I cannot get the handbrake to work well. It holds the car from standing, although only mainly on the passenger side. Pulling it up whilst rolling does nothing. I've had the rear brakes apart, and the pads are fine. It was a bit...

Hi. I have a 1996 ZX 1.9NA diesel estate, it normally runs very well, I've had it for 18 months with no problems.
In this really cold weather it has started to cut out when I take my foot off at junctions etc. It bump starts by leaving it in gear and using what momentum I have while putting my foot back down but this morning the engine actually...

Bought a Citroen Xsara Picasso a few weeks ago, it was sitting at the car dealers for a while and then with me for over a week. Went to start it and no luck. Did a jump start and it was fine, only got driving it for about 15 mins though.

Had to leave the car unfortunately for another 6 days before going near it and guess what? Dead again! Tried...

I am looking to get a new complete exhaust for the V6 and although I have a supplier I have used numerous times previously, I will be looking to see who is around and what sort of deals are available.

Anybody interested a new stainless V6 exhaust, either part system or the whole shooting match. If I get enough responses, I'll contact a few...

When does egr come into operation, mine woks all the time, but its not stuck on, even when idling,disconnected pipe from inlet, and exhaust fumes came out, at all revs, pulled pipe off egr , plugged end,and it stopped, and no anti polution fault now, more power, better mpg.23.4 from cold 0.9 miles, usually around 11, or 12 mpg

Got a c5 2.0 hdi 2002 to play with AA diagnosed as low pressure pump failure i have diagnosed bad pump circuit.
When jumped with 12v the pump runs engine might even start if i hadn't changed the internals of the filter and failed to reassemble properly - diesel all over the floor. :)

When the ignition is on or the engine cranked the feed for the...

I have spotted a few references to on board computers giving fuel consumption figures etc on Xantias and they are often advertised as a feature. I haven't found one on my HDI exclusive mk2 and yes I have RTFH.
Can anyone throw any light on this? Were they a cost option or standard on some models only?
Kind regards
Paul

Hi
I have read past posts about fitting cruse control on C5 HDi s I just wanted to know if this can be done on LX spec cars, I drove our works van which has cruse control and i thought thats great now i want it !!
From what i remeber reading if my car can do it i need
Cruse control stick switch
extra pedal switch
and a lexia session ?

is there...

this hole shown in te picture with the red arrow should be empty or should be introduced the other thing in the picture that is also with the red arrow? the pump is lucas delphi dpc. thank you

Hi all, I recently purchased a used synergie 2.0HDI v reg, when I viewed it the central locking was not working but all doors would unlock manually and open (passenger side rear sliding door only opened a little though as the filler cap has broken off and it thinks it is permanently open). After driving it home and leaving it on the drive over...

Newbie to the Forum and to C5 ownership

Does anyone know the part number for Park Control ECU for a 2009 C5

Any help appreciated
:?:

Hi
After the problem that I had with the hidrostatic locking of my Xantia's RFV engine (2lit. 16v, 2001) I've changed the spark plugs. the ones that were fitted are EYQUEM rfc42lz2e and it was running smoothly. the new ones that I've purchased are Denso K20TXR and I'm facing phenomena
that seems like lack of power and sometimes it seems like only...

Right...I've got an 03 C5 2.0 HDI est with a fkd ecu, the option I gave myself are..

A 2nd hand one from a breakers with the same 02810 ect, EDC15C2 ect numbers

The guy in the yard said that when I plug the ecu into mine, but using my trasnponder and key, it should start, if it doesnt, all I need to do is programe my key through a sequence he...

Haven't posted in a while!

Does a 206 GTi 138 rear silencer fit a C5 with the EW10J4 engine? I want a louder/better sounding one than standard so looking at the 206 GTi ones.

Cheers
Jabo

Well, today I went sledging with my 3 year old Sam.

Like a pillock, I dropped my car keys in the snow, in a big field. Two hours of desperate searching didn't find them. I had to get us all picked up by a friend and suffer a ride in a Poxhall Carlton, though I am very grateful for him coming to get us. Fortunately, as usual, I hadn't locked my...

Hi just used my C5 2003 HDI in the snow for the first time very impressed with grip have they got any traction control gizmos or anything :-D

I have 2 HDi Xantia Exclusives, one for every day use (172,000 miles) and a backup (84,000 miles). (In fact, given how little they're worth these days, I don't really understand why *everyone* doesn't have at least one !)

Anyway. now that the days have turned chilly again, I've started using the heated seat. Both cars exhibit the same fault, the...

Hi there.

I'm new to the forum as I've just purchased my first Citroen, a 2005 LWB Relay 2.2 HDi TD and have found the read very useful. However, I have my first request for help already as I've ordered a workshop manual, which is yet to arrive and I'm looking to get started on the van by changing the oil, filter + sump plug, but I was wondering...

In the photo below there's an aircon flap motor with a long splined shaft.

The standard motor is the one on the right which has a short spline.

The motor with the long spline is a mod and can be fitted if the splined hole in the flap chews up and the flap stops working.

So, does anyone know where the long spline version can be purchased....

Hello,

first post, looking forwards to enjoying this forum.

I need a bit of help to clear up some confusion, I have a C3 Picasso 1.6Hdi with FAP, the VIN is VF7**************[VIN obfuscated, can be read by forum staff]. I need to fit new rear pads, however there are several types on Eurocarparts, all allegedly for the same vehicle but at different prices, I spoke to them yesterday and...

Just about to do this having recieved my 5L bottles of flusg and new LHM for later.
I have read the how to do the change sticky and am ok with emptying the reservoir and brake bleeding, but have a question on what else to remove fluid from.

Spheres and brakes are a 'dead end' ?
My question is, if I change the fluid in the reservoir for...

Took the car to Manchester airport in December where it was left a fortnight while we went on hols. All working fine when we parked, with no show of any problem prior to that either.
On return to car the heater fan just won't go. Damned inconvenient at this time of year, especially since we came home loaded with flu.
The fuses check out OK and the...

Mechanical diesel injection pump, LUCAS VARITY
type DPC. This two things have to corresponded to each other.if they aren't how can I fix them?thank you

Is there any long term affects if dpf mapped out, can someone tell me what fuel is in reserve on c5 2.2 hdi 2003

Hi
Two day ago, while driving to work, I went into a puddle with my 2001 petrol Xantia. it stalled and I could not start it again. the vehicle was pulled out of the puddle.
I've tried to blow compressed air in order to dry it but to no avail. when I turn the ignition - the lights on the instrument panel goes on and it seems O.K. turning the key...

Hi All,

I have a fuel leak on my Xsara Picasso 2.0 2004 diesel :cry: . On the pump at the bottom sort of at the front there is a cover with 4 T40 torx screws. The diesel is flowing from this interface when running.

Can I just remove this cover and re-seal?

If so can it be done without removing the fuel pump. If I do have to remove the fuel pump...

Hi Guys
As some of you know i was in the process of changing my front pads when i found out that Halfords had given me the wrong ones.What i want to know is.Is there a special tool for winding the piston back in and if so what are they called and where do i get one ?.And what methods do you all use to wind it back in,if you haven't got said tool....

Somewhat concerningly, I've read the posts on here where the unlucky ones have had water sucked into the engines with C5 S1 HDis. Anyway, whilst I was fiddling with the throttle cable the other day, I thought I'd check the airfilter for cleanliness. Well, it needs changing, but it was also quite wet. Now, we've had some pretty deep water round...

Hi all, great forum and always very helpful.
I have a problem with the steering on my Berlingo 1.9 Diesel, 53 plate.
When cornering it seems to fight you and tries to correct itself especially on roundabouts. I have put up with this for about a year but lately the steering has become heavy and unresponsive, does not correct itself after turning,...

Its a thingy on right side of engine, with a rod and ball joint on it, think thats what its called anyway
Can it be faulty and affect mpg
C5 2.2 hdi 2003

My Xantia has an annoying problem with the heater, it's either a furnace at 30 degrees or blowing cold a couple of notches down with no in between. Is there an easy fix or do I need to attack the dashboard with torx bits? 8-[

Aware the engines are very thermal efficient, hence why I want to get the Eberspacher thingy working, however what temp should the car get to? Just wondered if I have a faulty thermostat.

Temp does not seem to go above 75 degrees, ie does even not reach half way, normally about a third of the way up.

Cheers

- Dave -

I bought a C3 this weekend ( second hand ) but since tuesday the fan is constantly on, no matter what I try it will not go off? I have spoken to the garage where I got it from, and they said it could be a sensor within the climate control, has anybody had this problem before and how did they fix it?

Hi,need to know where is located the temperature sensor on the c8?

I have a series 2 Xantia I am taking the drivers seat belt out how do I get to the top bolt on the door pillar

thanks

allan

Never joined a forum before, nice to chat to ppl with a brain, lol.
Unlike garage experts:-[:-[:-[:-[
You are real ppl in a real world :D

Hi guys,

I went and got petrol today and when I came out my centre colour display and satnav was not working at all. Just had a dead screen. No radio either. The Satnav unit was not lit up and on, so was not working at all. After driving and finding the car was okay and getting a bleep which I assume was the tyre pressure warning I always get. I...

I have a C5 2.2 Exclusive the front end seems very firm the back end seems very soft and I get a fair amount of roll. If I hit the sport button it seems to reduce the roll and firm up the rear end. My question is is it spheres or struts/rams.

2nd daughter has been on the phone about a problem she's having with her Xsara. Trouble is her car is in the UK and I'm in Spain so diagnosing is difficult. She's noticed that when she drives in reverse, she gets a scraping/clunking noise. Driving forward in any gear is fine. A couple of years ago her undertray fell on the front corner and got...

From reading the forum it looks like my rear exhaust box breaking off is quite common! I started getting this horrendous rattle while at Idle, but not the usual rorty exhaust note which is suprising given the size of the rear silencer box!The front pipe was resting on a suspension cross member.

It had corroded through the box side of the trumpet...

Does anyone know what the nominal leak off rate should be for injectors fitted to a 2.2HDi?

My MK1 C5 (156k miles) has started giving intermittent P0191 codes, registering low fuel pressure and throwing it into limp home mode - very annoying! It's only ever done this at idling speeds.

Done a leak off test today (using a £3 glass bottle spice...

After a few months of confusion trying to solve this problem, replacing whole throttle body with complete set of sensors but nothing works.So I send the car to a mech who are well experienced with handling citroen , he simply reach with his hand behind the engine compartment and pulled a sensor , clean it and the connector, put them back in and...

Guys, got question.

I am getting a warning saying that my brake pads are low on my dash. But this comes on intermittently (along with the Service light) and goes out. Sometimes it will come on when I touch the brakes, other times when I fully depress it, when the car appears to be warm and running it doesn't come on at all, other times the...

Probably be in Body Section

How easy or difficult is it to do a head gasket change on a 2.0 hdi engine in a C5?

Have been looking at cheap Xantia's - some spares or repairs (hence my other recent threads) but come across a C5 with what sounds like head gasket failure. It is a 2.0 HDI and the cooling system is over-pressurising.

Are these reasonably easy engines to work on?...

Hello,

I wonder if anyone has any ideas about this problem ! My 1999 2.0 HDi Xantia has recently started over reading on the rev counter by 1000rpm.

It all started when the instruments decided to flip over when strting despite having a new battery. The rev counter now sits at 0 against the needle when the ignition is off but as soon as I turn...

This happened today for first time since we bought this 2004 car 9 months ago. However, over the past 4 months or so we have had (from time to time) stop engine temperature light which we ignore since it comes and goes and seems connected to temp. gauge, which is not reading when warning comes on, but invariably sorts itself out after 20 or 30...

Hi,

Apols. for lengthy first post.

Vehicle is a J Reg ZX Avantage 1.4 petrol 5 door hatchback. I think this is too early to be a dim dip model, can't see relevant gubbins described elsewhere.

Done over 200k.

Simply put the sidelights and dash sidelight bulb don't come on any more on first setting. Problem is more complicated than this though...

RFJ motor (2 litre 16V, 2005 build) with AL4

I'm getting a constant P0597 code on this car; the thermo housing has been replaced with the blank variety, leaving the original plug floating free - some local sources insist this is OK without a reflash. I also note PSA propose a a blank thermo housing without comment on the diagnostic...