206cc to a 308cc How ? Why ? Everything 308cc

[Huskyxantia]

For reference part number for 308cc front lower balljoint

[Huskyxantia]

So new ball joint is in 90nm toqure setting hub , and all brake parts are in the car boot as im now waiting a new drive shaft I can confirm the on the car even scared ai , I showed the ai on my device via camera all movement and it came back with for your safety do not drive your car from what im seeing and how much floppy free play you are showing me it is very dangerous this has caused your inner tyre to wear plus the lower ball joint too... well, I got told off ......

Some photos of the shaft out of the way and some gearbox numbers as one seller claims the driver shaft is coded to the gear box ? What for ...

[Huskyxantia]

Ok!? Looks bloody fantastic that!

It did till it turned out to be a tad over 1mm to thick for the roof to close correctly, so its been done again in a grey soft cloth proper thickness too and a happy roof

[Huskyxantia]

The thickness of liners has been a consistent concern since 1912

Classic! Mind you, I haven't seen anything get jammed that badly by an extra couple of mil since my last drunken Saturday night." ... exit stage left lol

[MattBLancs]

So new ball joint is in 90nm toqure setting hub

Just checking: this isn't the torque setting you've installed that big 41mm ball joint into the hub at is it?

Haynes 308 figures for you:

[CitroJim]

You've been busy Husky! As regards the little Torx screws holding brake discs to the hub: I always use a small impact driver to remove them. It that fails, they're easy to drill out...

[Huskyxantia]

So new ball joint is in 90nm toqure setting hub

Just checking: this isn't the torque setting you've installed that big 41mm ball joint into the hub at is it?

Haynes 308 figures for you:

I thought it was more than 90 .. its not back on the car yet so when it is I can pound it up , ive another problem. Where the hell is the gearbox number on the gearbox

[Huskyxantia]

You've been busy Husky! As regards the little Torx screws holding brake discs to the hub: I always use a small impact driver to remove them. It that fails, they're easy to drill out...

Turning into a puzzle this one found 2 drive shafts but the seller is asking vin , reg , gearbox code .... digging around the gearbox now wheres the number ...

[Huskyxantia]

Found these numbers and that's it no others

[Huskyxantia]

I think this is the gearbox code .

[MattBLancs]

I'm not certain, but think "9HR" and "RGH" are engine codes - if I'm correct they should be part of your car's VIN number. Characters 6,7,8 should match:

https://en.wikibooks.org/wiki/Vehicle_I ... /VIN_Codes

[Huskyxantia]

I'm not certain, but think "9HR" and "RGH" are engine codes - if I'm correct they should be part of your car's VIN number. Characters 6,7,8 should match:

https://en.wikibooks.org/wiki/Vehicle_I ... /VIN_Codes

Ive just messaged the seller , we'll another seller they only needed the vin so fingers crossed this is all that's needed , the only difference i think they might be getting fussy over is
1 petrol drive shafts are not intended for diesel
2. 1.6hdi and 2.0hdi shafts are compatible
3. 5 speed box or 6 .

Which mines a 1.6hdi 6 speed , I'll just wait and see what this other seller comes back to me with.