Help identify correct mirror

[amazighman]

Hi
I have a 5008 mk1 2.0 hdi with an intermittent power folding driver wing mirror , setting off for work and the mirror wont unfold , have to try few times using cockpit switch for it to work , sometimes it works fine.
Tried sourcing a second hand mirror assembly but there are few different ones and I cant determine which one , can someone with access to parts diagrams help?
I can provide the vin

Cheers

[mickthemaverick]

I have access to a parts diagram for 2011 but I need to know your body style and gearbox type as well as your RPO number on the tyre sticker on the door. It is not labelled RPO but is usually the first number under the top line on the sticker. I need that info to feed into the parts system to find the right part as I do not have access to the VIN based system.

[amazighman]

Thanks for your reply

[amazighman]

I have access to a parts diagram for 2011 but I need to know your body style and gearbox type as well as your RPO number on the tyre sticker on the door. It is not labelled RPO but is usually the first number under the top line on the sticker. I need that info to feed into the parts system to find the right part as I do not have access to the VIN based system.

Hi.
Thanks for your reply
RPO 1249589
Body style MPV or SUV 7 seater
Gearbox Aisin 6 speed automatic ( not semi automatic)

[mickthemaverick]

Here you go:

5008 door mirror.pdf

Copied from ServiceBox backup

(139.25 KiB) Downloaded 36 times

[amazighman]

Here you go:

5008 door mirror.pdf

Wonderful stuff , I could not thank you enough
Thanks a lot.

[amazighman]

If you dont mind could you help identify the correct number for left side driveshaft? The short one?
Looked on Autodoc and there seems to be two different sizes
Many thanks

[mickthemaverick]

This may help:

5008 Driveshafts.pdf

Copied from Service Box

(147.73 KiB) Downloaded 19 times

[amazighman]

This may help:

5008 Driveshafts.pdf

Thank you very much Indeed.

[amazighman]

This may help:

5008 Driveshafts.pdf

Is it advisable to replace the driveshaft oil seal in the transmission?

[mickthemaverick]

Yes I would as it is cheap by comparison to stripping it all down again should it fail in the future. Plus if you are replacing the shaft then it makes sense to have a new seal to bed to it.

[amazighman]

Yes I would as it is cheap by comparison to stripping it all down again should it fail in the future. Plus if you are replacing the shaft then it makes sense to have a new seal to bed to it.

Can I be cheeky , and sorry I have been a pain , whats the part number for the seal left side?
Thanks a lot

[mickthemaverick]

That will have to wait as I cannot access my system at the moment, I will have a look when I can

[amazighman]

thanks for all your help , Wouldn't have been able to locate the parts without you , my online parts diagram partsouq .com doesn't accept Peugeot vin number , only manual selection which isn't accurate on some parts
Cheers

[mickthemaverick]

seals.pdf

Copied frm servicebox.

(121.53 KiB) Downloaded 31 times