Injector torque

[Zsolo1]

Hello!
I need help!
How to tighten the injector clamping screw of a 2015 Citroen c4 picasso 2.0 HDI, or how many Nm should I tighten it with?
Screw size M8
Delphi injector
Engine DW10FD

VF7**************[VIN obfuscated, can be read by forum staff]

Thx Zsolo

[mickthemaverick]

Have a look through this : https://www.pugaddicts.co.uk/2012/12/pe ... -data.html

[Zsolo1]

Thank you!
Do you think the injectors on the two different engines should be tightened the same way, even though one is Bosch and the other Delphi?
DW10FD vs DV10TD?

[mickthemaverick]

As I understand it the difference between those engines is in the emissions control so I would expect them to be the same torque settings for the injector clamps.

[Zsolo1]

I read somewhere that the Delphi injector must be pre-tensioned with a minimum torque ("X" Nm), and then secured to the appropriate degree with a protractor. The difference, according to my information, is that the Bosch works with lower pressure. That's why there is a different procedure.

[mickthemaverick]

Fair enough you already know more about them than me!

[Zsolo1]

DW10FD (2.0 BlueHDi – modern Delphi)
Clamping bolt torque: ≈ 7–9 Nm + 65–75° tightening
(typical: 8 Nm + 70°)
DW10TD (older 2.0 HDi)
Clamping bolt torque: ≈ 7 Nm + 60–65° tightening

Unfortunately, what I know is not official...