Xantia IR Fob Blade replacement

StevieM · Post by **StevieM** » 27 Aug 2010, 00:28

Folks,

Just ordered replacement IR, 2 button fob from ebay for my '95 Xantia.
-
Scoured web....seems that car actually learns fob code if ignition on/main fob button depressed with fob close to receiver dome near rear-view mirror....will give it a go.
-
Question is...to replace the blade with mine, do I prise the blade rivets apart, or drill out using my drill press?
-
Many Tks, Steve

Post by **xantia_v6** » 27 Aug 2010, 07:40

Prise them apart.

If your old casing is good, then just swap the new PCB into it.