hydraulic pump bolt

davethewheel · Unread post by **davethewheel** » 21 Feb 2005, 21:28

when replacing a bust abs sensor i noticed that the bolt that secures the pulley on the hydraulic pump is missing , it must have beem missing for some time as the threads are rusty , i need to find out what the thread size is as i may have to run a tap through first before i can get a bolt in.

AndersDK · Unread post by **AndersDK** » 21 Feb 2005, 22:03

Not supposed to be a bolt there.
I remember from my CX that these pumps (located on the gearbox like on BX diesels) had a 9mm fine pitch thread in the pulley axle. The same thread is found on the bolt that holds the pump (on CX & BX diesels).

davethewheel · Unread post by **davethewheel** » 21 Feb 2005, 22:08

how is the pulley fastened to the shaft?

AndersDK · Unread post by **AndersDK** » 21 Feb 2005, 22:30

Crimped ...

davethewheel · Unread post by **davethewheel** » 21 Feb 2005, 23:14

ok cheers, at least i don't have to try and get a bolt to fit in there.