turbo setting

[frankieyeha]

put new turbo and wastegate now getting P2562 not getting enough turbo charge on the torque app the boost clock says .29 is this right or should be higher on tickover.

[mickthemaverick]

I'd check through the induction piping for air leaks, tightening up any suspect joints and then run another diagnostic.

[frankieyeha]

Is that the pipe that comes of the air filter box.

[RichardW]

What fault did you have before? Is there actually a sensor on the turbo? Have you reconnected the vac pipe to the turbo actuator and is it working?

[frankieyeha]

Yes it's working

[frankieyeha]

The first code was p2563 changed the waste gate now it's this code.

[mickthemaverick]

You may get some ideas from this site: https://iamcarhacker.com/fix-p2562/

[frankieyeha]

I've been on there.

[frankieyeha]

on my machine under live data in the list 0ne is control module voltage it says 0 volts in red i checked another car with the same engine his says 12.5 volts can some1 tell me what the control module is thanks in advance.

[RichardW]

There's a boost control solenoid somewhere, possibly down the back of the engine. Follow the vac hose from the turbo, checking it for splits as you go.

[frankieyeha]

Yes it's at the front eight of the engine replaced it with a brand new one and checked the hoses

[frankieyeha]

I've just noticed the PCB is leaking oil that might be one of my problems.