Peugeot 807 gyroscope sensor location

This is the Forum for all your Peugeot Technical Questions, Problems or Advice.
McWarnaly
Posts: 2
Joined: 04 Oct 2023, 12:41

Peugeot 807 gyroscope sensor location

Unread post by McWarnaly »

Hi, does anyone know where the gyroscope sensor of 807 located?
User avatar
GiveMeABreak
(Donor 2016)
Posts: 42019
Joined: 15 Sep 2015, 19:38
x 6955

Re: Peugeot 807 gyroscope sensor location

Unread post by GiveMeABreak »

There's 2, one on the left and one on the right.

Access requires the deactivation of the airbag system and battery disconnection first, then on each side, partial removal of the front door seal trim where it meets at the lower middle part to provide access to the sill trim bolts.

These bolts are then removed along with the moulding to reveal the airbag acceleration sensor brackets with 4 bolts. Remove these to reveal the connector and the sensor.
Please note, I'm no longer active on the Forum, so won't respond to messages.

Marc
wheeler
Posts: 7893
Joined: 21 Sep 2002, 19:07
x 1043

Re: Peugeot 807 gyroscope sensor location

Unread post by wheeler »

Im getting the impression the OP means the gyroscope for the ESP?? Yaw sensor?
They are normally located on the floor of the cab behind the airbag ECU.
User avatar
GiveMeABreak
(Donor 2016)
Posts: 42019
Joined: 15 Sep 2015, 19:38
x 6955

Re: Peugeot 807 gyroscope sensor location

Unread post by GiveMeABreak »

Possibly - so just to clarify the info I gave was for the Airbag acceleration sensors - so if it's the ESP inertia unit, then it's usually located in the centre of the vehicle somewhere in the front between the front seats on a car where the centre binnacle would be. With the gear controls mounted on the dash on these, it may be underneath there near the floor though, but I can't say for sure.
Please note, I'm no longer active on the Forum, so won't respond to messages.

Marc