DS7 daytime running light
-
CliveMa
- Posts: 3
- Joined: 06 Apr 2023, 19:26
DS7 daytime running light
Lights on one side not working.... Any ideas?
-
Paul-R
- Moderating Team
- Posts: 8964
- Joined: 07 May 2009, 16:24
- x 1858
Re: DS7 daytime running light
What happens when you put the sidelamps on?
As I get older I think a lot about the hereafter - I go into a room and then wonder what I'm here after.
Inside every old person is a young person wondering what the hell happened.
"Trying is the first step towards failure" ~ Homer J Simpson
Inside every old person is a young person wondering what the hell happened.
"Trying is the first step towards failure" ~ Homer J Simpson
-
GiveMeABreak
- (Donor 2016)
- Posts: 42019
- Joined: 15 Sep 2015, 19:38
- x 6955
Re: DS7 daytime running light
The Daytime Running Lamps on the DS7 are controlled by the BSI, so unless you can locate an electrical issue at the light module, it's going to need a diagnostic / dealer visit. They don't even provide a comprehensive fuse list in the owner's manual, preferring you to seek assistance from the dealership - as these have so much electrical tech on them - so lots to go wrong.
It may possibly need a new module, but here is the connector you need to check:
It may possibly need a new module, but here is the connector you need to check:
Please note, I'm no longer active on the Forum, so won't respond to messages.
Marc
Marc
-
CliveMa
- Posts: 3
- Joined: 06 Apr 2023, 19:26
Re: DS7 daytime running light
Is the connector accessable without a major dismantling?
-
GiveMeABreak
- (Donor 2016)
- Posts: 42019
- Joined: 15 Sep 2015, 19:38
- x 6955
Re: DS7 daytime running light
Well not without taking the wheel off and the wheel arch shield protection to get at it to be honest - you'd be the better judge of that Clive as you have one to work on, but at least you know where it is. I was thinking that it might be worth checking the connector is on securely.
Please note, I'm no longer active on the Forum, so won't respond to messages.
Marc
Marc
-
Paul-R
- Moderating Team
- Posts: 8964
- Joined: 07 May 2009, 16:24
- x 1858
Re: DS7 daytime running light
?
As I get older I think a lot about the hereafter - I go into a room and then wonder what I'm here after.
Inside every old person is a young person wondering what the hell happened.
"Trying is the first step towards failure" ~ Homer J Simpson
Inside every old person is a young person wondering what the hell happened.
"Trying is the first step towards failure" ~ Homer J Simpson
-
CliveMa
- Posts: 3
- Joined: 06 Apr 2023, 19:26
Re: DS7 daytime running light
Putting sidelights on makes no difference. 
-
Screwloose
- Posts: 1
- Joined: 18 May 2024, 19:41
- x 1
Re: DS7 daytime running light
I have recently suffered the same with my DS7.
Driver side DRL intermittently not operating.
I choose to dismantle the wheel arch and remove the unit. Not overly difficult but could have been made easier.
The unit consists of a plastic housing that holds the LEDs and a light bar and on the back there is a heat sink. This all sits in a large space in the bumper cavity in front of the wheel.
These units are susceptible to corrosion and on inspection, the corrosion has penetrated the PCB in the heat sink housing. The rubber seal had failed and there was water ingress into the unit. A thorough clean and careful reassembly has saved me a small fortune in a replacement unit and indeed dealership fees.
Not advisable if you are inexperienced but if you are confident in maintenance and repair, this is fixable if the ingress has not damaged the PCB.
Driver side DRL intermittently not operating.
I choose to dismantle the wheel arch and remove the unit. Not overly difficult but could have been made easier.
The unit consists of a plastic housing that holds the LEDs and a light bar and on the back there is a heat sink. This all sits in a large space in the bumper cavity in front of the wheel.
These units are susceptible to corrosion and on inspection, the corrosion has penetrated the PCB in the heat sink housing. The rubber seal had failed and there was water ingress into the unit. A thorough clean and careful reassembly has saved me a small fortune in a replacement unit and indeed dealership fees.
Not advisable if you are inexperienced but if you are confident in maintenance and repair, this is fixable if the ingress has not damaged the PCB.
Last edited by Screwloose on 18 May 2024, 21:07, edited 1 time in total.
-
GiveMeABreak
- (Donor 2016)
- Posts: 42019
- Joined: 15 Sep 2015, 19:38
- x 6955
Re: DS7 daytime running light
Thanks for the contribution, I'm sure it will provide some clarity for others in the same boat.
Please note, I'm no longer active on the Forum, so won't respond to messages.
Marc
Marc
-
Djandree
- (Donor 2025)
- Posts: 199
- Joined: 17 Oct 2019, 00:10
- x 38
Re: DS7 daytime running light
In most cases water ingress into Dlr. Pcb will look like this...