2012 1.6hdi P0405 fault egr changed
Moderator: RichardW
-
- Posts: 4
- Joined: 19 May 2021, 09:21
- Location: Bradford
- My Cars: Peugeot Partner tepee 2012
Peugeot partner van 2011
2012 1.6hdi P0405 fault egr changed
Hi peeps, I'm having a problem with my car going into limp mode with p0405 have changed the egr valve and still no joy this code happened after the egr valve had been changed prior to that I was getting p3007. Any help would be appreciated. Also where can I get a proper scan tool/software for Peugoet. Is it the Planet or diagbox I need. Thanks
-
OnlineGiveMeABreak
- Forum Admin Team
- Posts: 37000
- Joined: 15 Sep 2015, 19:38
- Location: West Wales
- My Cars: C3 Aircross SUV HDi Flair Peperoncino Red (The Chili Hornet)
C5 X7 2.0 HDi Exclusive Mativoire Beige (The Golden Hornet)
C3 1.6 HDi Exclusive Aluminium Grey (The Silver Hornet)
C5 MK II 2.0 HDi Exclusive Obsidian Black
C5 MK I 2.0 HDi SX Wicked Red
Xantia S2 2.0 HDi SX Hermes Red
C15 Romahome White
XM 2.0 Turbo Prestige Emerald Green Pearlescent
XM 2.0 Turbo Prestige Polar White
XM 2.0 SX Polar White
CX 20 Polar White
GS 1220 Geranium Red
CX 2.4 Prestige C-Matic Nevada Beige
GS 1000 Cedreat Yellow - x 5645
Re: 2012 1.6hdi P0405 fault egr changed
I think you do actually need to do some further investigation as P0405 relates to the Electric EGR valve repeat signal fault: Copy voltage too low. So there is the possibility of the supply voltage or depending on your engine may need some terminal boxes to properly troubleshoot and eliminate certain components / connections.
If you have the VIN, pop that up (automasked on post submission) that would help determine the exact engine and ECU you have.
If you have the VIN, pop that up (automasked on post submission) that would help determine the exact engine and ECU you have.
Please Don't PM Me For Technical Help
Marc
Marc
-
- Posts: 4
- Joined: 19 May 2021, 09:21
- Location: Bradford
- My Cars: Peugeot Partner tepee 2012
Peugeot partner van 2011
Re: 2012 1.6hdi P0405 fault egr changed
Vin
VF3**************[VIN obfuscated, can be read by forum staff]
It is a 1.6hdi 2012 with dpf
VF3**************[VIN obfuscated, can be read by forum staff]
It is a 1.6hdi 2012 with dpf
-
OnlineGiveMeABreak
- Forum Admin Team
- Posts: 37000
- Joined: 15 Sep 2015, 19:38
- Location: West Wales
- My Cars: C3 Aircross SUV HDi Flair Peperoncino Red (The Chili Hornet)
C5 X7 2.0 HDi Exclusive Mativoire Beige (The Golden Hornet)
C3 1.6 HDi Exclusive Aluminium Grey (The Silver Hornet)
C5 MK II 2.0 HDi Exclusive Obsidian Black
C5 MK I 2.0 HDi SX Wicked Red
Xantia S2 2.0 HDi SX Hermes Red
C15 Romahome White
XM 2.0 Turbo Prestige Emerald Green Pearlescent
XM 2.0 Turbo Prestige Polar White
XM 2.0 SX Polar White
CX 20 Polar White
GS 1220 Geranium Red
CX 2.4 Prestige C-Matic Nevada Beige
GS 1000 Cedreat Yellow - x 5645
Re: 2012 1.6hdi P0405 fault egr changed
Ok, so you actually have a 2011 model (built 7th September 2011), so was a late registered vehicle with 1.6 HDi 92 (DV6DTED) engine and Bosch Injection.
So ignore the preovious fault - as you can see it is slightly different for this vehicle. In your case, the P0405 Fault states:
So I would be checking the electrical side, as the EGR is not getting enough voltage. Check the electrical connections to the EGR - especially the pins in the connector to make sure they are not loose.
So ignore the preovious fault - as you can see it is slightly different for this vehicle. In your case, the P0405 Fault states:
Fault Code: | P0405 |
Description of Fault: | Measurement of the position of the EGR valve: Open circuit or short circuit to earth. Voltage less than 0.3 V for 500 ms |
Conditions for Fault to clear: | Driving for 5 minutes |
Downgrade Modes whilst Fault is active: | Forced regeneration via the Diagnostic tool is prohibited whilst this fault is active. Management Info Light is also on when fault is active. |
Symptoms: |
|
Suspect Areas: |
|
Please Don't PM Me For Technical Help
Marc
Marc
-
- Posts: 4
- Joined: 19 May 2021, 09:21
- Location: Bradford
- My Cars: Peugeot Partner tepee 2012
Peugeot partner van 2011
Re: 2012 1.6hdi P0405 fault egr changed
Thank you very much for your reply. Do you recommend using a electrical cleaner. I also change the sensor near the actuator. Seems like a possible problem with the harness or plugs.
- xantia_v6
- Forum Admin Team
- Posts: 9052
- Joined: 09 Nov 2005, 22:03
- Location: France or NewZealand
- Lexia Available: Yes
- My Cars: -
1997 Citroen Xantia V6 (France)
1999 Citroen XM V6 ES9 (France)
2011 Peugeot 308 CC THP 155 (NZ)
1975 Jaguar XJ-S pre-HE (NZ) - x 825
Re: 2012 1.6hdi P0405 fault egr changed
Did you fit a new genuine valve, or a used or aftermarket part? It is possible that the valve is not compatible.
-
- Posts: 4
- Joined: 19 May 2021, 09:21
- Location: Bradford
- My Cars: Peugeot Partner tepee 2012
Peugeot partner van 2011
Re: 2012 1.6hdi P0405 fault egr changed
I fitted a new one but don't think it was oem one. However I have now fitted 2 new ones
-
- (Donor 2020)
- Posts: 279
- Joined: 26 Feb 2002, 23:49
- Location: west London,
- My Cars: different types over the years.when younger
Peugeot 405 estate
xantia estste 1.9d
c5 2.2 hdi hatchback
Peugeot 3008 1.6 hdi
Hyundai tuscon - x 18
Re: 2012 1.6hdi P0405 fault egr changed
Did you by any chance get them from Euro Car Parts
Steve
C5 2.2hdi auto until I sell it (sold it) now have Peugeot 3008 1.6HDI (Now sold)
Had the jab a couple of days ago. Feb 21
C5 2.2hdi auto until I sell it (sold it) now have Peugeot 3008 1.6HDI (Now sold)
Had the jab a couple of days ago. Feb 21