xantia CT, V6, 2.1TD and HDI 110 owners read this.

ActivaV6uk · Unread post by **ActivaV6uk** » 01 May 2005, 17:07

Hi all,
I posted a couple of weeks ago about the way to solve rattles (sounds like a loose heat shield) on the above mentioned models. If you get a rattle when your decelerating or in low revs (1250 - 2500) your upper engine mount has problems. Because so many Activa owners have this problem (including my wife) I have done some work on this.
Firstly its not a particularly hard job I just did it in 20 minutes with only a 16mm spanner and a new mount (the old ones centre was removed by hand that’s how badly it had failed).
because this is something that needs pictures and is a common problem that seems to hit at around the 8 year mark (mileage doesn’t seem to matter) I will create an article on www.activanet.co.uk under the repair section (which doesn’t exist at the moment).
Andy

citronut · Unread post by **citronut** » 01 May 2005, 17:13

dose you wife rattle out side thi rev range ha ha best regards malcolm

macaroni · Unread post by **macaroni** » 02 May 2005, 00:24

My Activa does have a slightly metallic rattle that has become more noticeable driving around with the windows open. It seems to co-incide with bumpy roads, might this be the same thing?

ActivaV6uk · Unread post by **ActivaV6uk** » 02 May 2005, 03:15

nope i'd put money on that being the rear activa ram bush - citroen need to start using better bushes!
Andy

macaroni · Unread post by **macaroni** » 02 May 2005, 15:10

This was only replaced fairly recently (29/05/04, 12000 miles ago) and I was led to believe that the noise that makes is quite loud and hard compared to the size of the bush. Could and probably am wrong though.

ActivaV6uk · Unread post by **ActivaV6uk** » 02 May 2005, 15:38

i have the answer

- bring it to the FCS i'm sure your fellow activanet memebers can sort it for you there

Andy