When they engage they both work fine, well for a little while, but more often than not it throws up a service warning light on the head up display when adjusting speed or switching between them
Vin VF7**************[VIN obfuscated, can be read by forum staff]
The selection of Limiter/Cruise is via a rotary switch with a pause button above it and the +/- speed settings for both around it.
I have noticed a delay in the display showing a switch between both modes, sometimes up to 10 seconds.
If i push down on the rotary switch as i move between settings the display shows up mode instantly.
Looking on Service.Citroen it shows the buttons/rotary switch as a separate item but to my mind it seems the 2 parts are not making a proper contact, i am using my limited brain and knowledge of electronic wizardry on a 14 yr old car to think that there is a circuit that needs to be made ( key fob buttons etc ) and when i squeeze the 2 parts together it all works lol
So could i spray contact cleaner between the top and bottom parts without doing any damage to any other parts ?
As usual totally going off on a whim but hey, until you try