Citroen C5 x7 2012 tyre pressure modul

[goggi10]

Hi
Can you help me out. Can somone tell me wich tyer pressure module is for my C5 X7 2012 vin BL562351. I found one cheap but its Siemens VDO serial no 9660499380. Thanks

[GiveMeABreak]

You need Part number 6590 CZ for your vehicle.

https://www.proxyparts.com/car-parts-st ... id/919497/

[leocitroen]

Hi goggi,
Do you need emitter or receiver??

Marc, is this part number for non OEM?? Because I ordered for myself by this part number..



And also you can see VDO emitters for C5 at the bottom link.
http://www.vdo.com/media/746440/2017-10 ... n-list.pdf

[leocitroen]

Hi Marc,
Goggi asked for "tyer pressure module is for my C5 X7 2012"... Emitter MODULE..
You give "Part number 6590 CZ", what is PDC module (if I'm right Parking Distance Controller)...???
Also by his VIN number .. no factory-installed TPMS.

UPDATE: That one Goggi asked for is probably Siemens VDO (5430 54 or 56 - INFLAT RECEIVER) for C5 II.

[GiveMeABreak]

Yes, I have lost the plot again - you are correct Leo, apologies, I was getting this mixed up with another query on another site!

AS the OP has the 138 DWBTED4 engine and 225 / 55 / R17 wheels, he will need:
Part 1610529180 for the Receiver (10)
Part 9811536380 for the Wheel Transmitter modules (1) for his RPO.
Part 1610695980 for the 2 clips for the receiver module. (70)

[Paul-R]

AS the OP has the 138 DWBTED4 engine ...

I presume that info came from the VIN but I thought that by 2012 all 2.0HDi engines were 163bhp? Unless Serbian models were denied the more powerful engines of course.

[GiveMeABreak]

Yes, double checked Paul as that was my first thought - but no - even the warranty start date was 2012!

[Kees]

@ GiveMeABreak (Mark):
Hai, Marc.
Can you tell me, where this tyre module is hidden in my C5 X7 3.0/24.
i have a little problem with the Can communication.
Greetings,
Kees.

[GiveMeABreak]

It's fitted in the rear left wing in the luggage compartment, behind the trim.

[Kees]

Thanks, Marc.
greetings,
Kees.

[Kees]

Hi,Marc.
Today i discover the tyre pressure, i also notice, a unused connector at the same bracket. it's the same they used for an relai's, but this one has only 3 wires.
My qustion is, is this one possible for an camera.
I was looking in the past if it's possible to mount one, but can not find any information about it, like the wiring harness.
Ones i saw a tourer equipped with one, i have the VIN of this car, is FV7RW5FV8CL522464
maby perhaps you can find the information i need?
greetings,
Kees.

[GiveMeABreak]

Hi Kees. It's not possible to fit a rear camera on the RT4. Only later Tourer models with the later RT6 units or later systems had the reversing camera fitted. Saloons don't have the wiring present and the RT4 is not equipped to support it.

Additional connections in the boot may be for the trailer relay unit that was optionally fitted for towbar electrics.

[Kees]

Hai, Marc.
Thanks for youre answer, but i think, that you forget, that i change the RT4 with an NG4 (harman Becker) as far as i know has this unit more video input's.
Greetings,
Kees.

[GiveMeABreak]

Hi Kees. No still not possible and not supported by the head unit. The earliest system to support a camera was the RT6 and specifically, later hardware versions of the RT6 only. Only the later Tourer had the camera wiring harness.

[ozzdownunder]

I am trying to locate the receiver module for the Citroen C5X7 2014 Vin VF7**************[VIN obfuscated, can be read by forum staff] SEDAN. I have attached a picture of the module. Its a 12 pin connector. I have seen a version of this one (Made in France) on
Aliexpress.
>>> https://www.aliexpress.com/item/1005009 ... 211%210%21 Checking to see if any one else has bought this one and if it worked ok.