Needs a couple of things to make it perfect though!
Can anyone tell me which bulbs go in the dash, and cente consoles?
Also, where is the siren? I can see the alarm going off (flashing lights) but there is no noise - is there a switch or something that i need to turn?
Finally, is there anywhere i can get a replacement key fob? I have one already, but want another one for the spare key!
Thanks
Q
Just got a ZX TD
Moderator: RichardW
-
- Posts: 1635
- Joined: 03 Oct 2003, 00:50
- Location: United Kingdom
- My Cars:
- x 1
-
- Forum Treasurer
- Posts: 10872
- Joined: 07 Aug 2002, 17:12
- Location: United Kingdom
- My Cars: MK2 '17 C4GP 1.6 BlueHDi 120
'13 3008 1.6 HDi GripControl - x 996
Dash bulbs are all the same - the 1.2W push in type. Change them all at once, as you don't want to to it twice. Ignore Haynes advice about the heater bulbs - remove radio, then front plate, then carefully prise the front off the heater control box, knobs and all, and the bulbs can then be changed. Leave the centre console apart whilst you do the instruments as this leaves loads of room to get in to unclip the speedo cable, and avoids all the malarky Haynes outlines with the heater duct. On mine it was just possible to ease the instruments out past the airbag connection with the steering wheel in the lowest position. Only takes a couple of hours.
If it has the separate key fob to activate the central locking, getting another is difficult as it needs to be hard coded to the receiver - it is possible (there are some instructions on here somewhere), but you need a fine soldering iron and drill - and the skill to use it!
If it has the separate key fob to activate the central locking, getting another is difficult as it needs to be hard coded to the receiver - it is possible (there are some instructions on here somewhere), but you need a fine soldering iron and drill - and the skill to use it!