Do we know the material return pipe blocks are made off ?

Stickyfinger · Unread post by **Stickyfinger** » 05 May 2015, 19:45

10mm (outside dia of connector)....Bird Leg rings in Stainless steel for edge support.

Unread post by **xantia_v6** » 05 May 2015, 20:03

Maybe a Carvey would come in handy?

Stickyfinger · Unread post by **Stickyfinger** » 05 May 2015, 20:08

xantia_v6 wrote:Maybe a Carvey would come in handy?

Sounds good

Gibbo2286 · Unread post by **Gibbo2286** » 06 May 2015, 09:33

elma wrote:With the 3d printer it would be quite easy to make it a push click type connector using the bevel on the pipes to restrain the part. We've been redesigning the printer for nearly a month now getting the accuracy decent, its really good at holes and may not need reaming when printed. I'm too busy today and tomorrow, I'll do my best to get a cad drawing of what I've got in mind up shortly. With any luck I'll be back from college about 23.00 so it may get done tonight, wouldn't hold breath though..

Have you seen this stuff elma? http://www.biomebioplastics.com/biome-b ... -printing/

Unread post by **elma** » 06 May 2015, 13:32

Its new to me, I just had a quick look. Sounds interesting, I'll have a good look later.

French Car Forum

Do we know the material return pipe blocks are made off ?

Re: Do we know the material return pipe blocks are made off

Re: Do we know the material return pipe blocks are made off

Re: Do we know the material return pipe blocks are made off

Re: Do we know the material return pipe blocks are made off

Re: Do we know the material return pipe blocks are made off