C5 Crankshaft pulley

[SaabC5]

Can any Citroen boffins out there give me the torque setting for the dual mass crankshaft pulley on the 2.2 DW12TED4 please.

[wheeler]

pre tighten to 70Nm then 82 degrees +or- 5 degrees.

[SaabC5]

Thank you very much.

[kenhall1202]

Citroen DocBackup Repair Manual saysfor the DW12TED4 engine (under procedure B1EG1UP0 Removing - refitting : Timing belt : DW12TED4 TURBO DIESEL) :

"Coat the bolt (19) with LOCTITE FRENETANCH .
Fit :
Crankshaft pulley (21)
The tool [6]
The screw (19) with the washer (31), tighten to 4 ± 0,4 m.daN Finish with an angular tightening of 51° ± 5 °"

Tool [6] is the flywheel locking tool.

EDIT
For the later DW12TED4 FAP engine the following instruction applies:

"Coat the bolt (9) with LOCTITE FRENETANCH .
Fit :
The accessories drive pulley (10)
The bolt (9) with its washer
Tighten the screw (9) to 7 ± 0,7 m.daN Angular tightening A : 82 ± 3 ° " .

Take your pick! RP number would help to clarify.

[wheeler]

Never seen a 2.2HDi C5 without FAP...
I normally torque them to FT with an air gun