XANT/406 heater blower

Unread post by **citroenxm** » 30 Oct 2009, 22:50

Malcolm,
Its MOST Likly SUCKING then and not blowing.....

406 may very well use the XM one..

Paul

citronut · Unread post by **citronut** » 30 Oct 2009, 22:53

just the one pair for now Jim and what is the cost

regards malcolm

Unread post by **CitroJim** » 30 Oct 2009, 22:54

citronut wrote:just the one pair for now Jim and what is the cost

Two it is. Cost we'll discuss later...

citronut · Unread post by **citronut** » 30 Oct 2009, 22:56

Paul the 406 blower is in the same area as the Xant but it sits around the other way, the 4 pin plug block is towards the bulkhead on the 406 and towatds the glove box on the Xant

regards malcolm

Unread post by **citroenxm** » 30 Oct 2009, 22:59

Hmmmmm.... <scratches head> I can only assume its going backwards then?? Its the Fan blades the same colour?? Black?

If your not getting a lot of air, it can only be sucking..

Paul

citronut · Unread post by **citronut** » 30 Oct 2009, 23:05

so it cant be one of the direction flap servos just not openning a flap

regards malcolm

citronut · Unread post by **citronut** » 02 Nov 2009, 19:20

today i droped the P reg PUG 406 fan unit back out of my XANT to compaire the fan and motor direction, both fans have direction arrows embossed on thear nose cone, the pug one not only spinns the opposite direction but the finns face the other way to,

so i pulled the motor and impeller out of both fan units and stuck the XANT one back in, BONGO full blow when fan at full speed, and all the intermediate speeds work as well

regards malcolm