Hi all...
Been reading closly about ALL blower faults and fixtures, but they havent cured a fault I have on a customers car..
A dead blower, it DOES work, tried it on another S2 with Air con, swapped the electronic long module that is attached to the side of the heater to the right of the blower, looked in to the "Burnt out" ignition syndrome, EVEN tried another ignition switch.. and I still cant get it to go... is there a relay hidden behind the dash somewere?? OH also, the air con switch DOES NOT work, no light etc etc on it..... So have I a new problem here or am I missing something?
Many thanks
PAul
Oh no ANOTHER blower problem!
-
citroenxm
- Fallen Hero
- Posts: 8061
- Joined: 30 Dec 2004, 23:10
- x 70
Oh no ANOTHER blower problem!
Sharing a pug 207 1.6 hdi Sw 16v.
M reg Xm 2.1 td auto exclusive S2 269k and rising
L reg XM V6 12v SEi auto .. Light project
A very sad...
1994 XM 2.1 d auto
M reg Xm 2.1 td auto exclusive S2 269k and rising
L reg XM V6 12v SEi auto .. Light project
A very sad...
1994 XM 2.1 d auto
-
Peter.N.
- Moderating Team
- Posts: 11774
- Joined: 02 Apr 2005, 16:11
- x 1240
Hi Paul
If its the same system as the XM there is a relay somewhere because it wont work unless the engine is running. This means that either there is a connection to the alternator exciter circuit or a voltage sensitive circuit that will only switch it on when the battery comes up to charging level, unless there is a voltage sensing system in the heater control unit. As usual the manuals don't help much. The CX manual showed the location of the relays - why couldn't they do it with the others?
Peter
If its the same system as the XM there is a relay somewhere because it wont work unless the engine is running. This means that either there is a connection to the alternator exciter circuit or a voltage sensitive circuit that will only switch it on when the battery comes up to charging level, unless there is a voltage sensing system in the heater control unit. As usual the manuals don't help much. The CX manual showed the location of the relays - why couldn't they do it with the others?
Peter
-
Clogzz
- Posts: 2125
- Joined: 15 May 2005, 18:04
- x 40
-
RichardW
- Forum Treasurer
- Posts: 12494
- Joined: 07 Aug 2002, 17:12
- x 1449
I had trouble with my S2 - for some reason the swtiching voltage on the relay disappeared. The relay is a 35A one above the throttle pedal. I just piggy backed a new fused supply to the switch pin from the swtiched side of ignition wiring. Has worked (20k miles) since OK. Not sure if this is connected to the A/C not working or not - could perhaps be a dodgy earth around the steering column somewhere??
Richard W
-
citroenxm
- Fallen Hero
- Posts: 8061
- Joined: 30 Dec 2004, 23:10
- x 70
THANKYOU Peter and Clogzz..
The diagram cerainly will help me out now... It has to be the ONLY problem left...
Peter, I did wonder if it was the same system, thankyou for confirming...
Rgds
PAUL
The diagram cerainly will help me out now... It has to be the ONLY problem left...
Peter, I did wonder if it was the same system, thankyou for confirming...
Rgds
PAUL
Sharing a pug 207 1.6 hdi Sw 16v.
M reg Xm 2.1 td auto exclusive S2 269k and rising
L reg XM V6 12v SEi auto .. Light project
A very sad...
1994 XM 2.1 d auto
M reg Xm 2.1 td auto exclusive S2 269k and rising
L reg XM V6 12v SEi auto .. Light project
A very sad...
1994 XM 2.1 d auto
