Hi everyone
I drive a Peugeot 3008 2014 crossway I have a problem as my boot won’t unlock and hazards have stopped working but indicators are fine and the central locking is doing what it wants
So I’ve checked all fuses all ok
I’ve put in a new boot loom made no difference
I’ve done bsi resets even removed the shun fuse and still no difference any help or advice would be greatly appreciated thanks
Electrical issues
-
Paul-R
- Moderating Team
- Posts: 8959
- Joined: 07 May 2009, 16:24
- x 1855
Re: Electrical issues
How old is the current battery?
As I get older I think a lot about the hereafter - I go into a room and then wonder what I'm here after.
Inside every old person is a young person wondering what the hell happened.
"Trying is the first step towards failure" ~ Homer J Simpson
Inside every old person is a young person wondering what the hell happened.
"Trying is the first step towards failure" ~ Homer J Simpson
-
Peugeot dan
- Posts: 3
- Joined: 28 Dec 2025, 11:33
Re: Electrical issues
I’m not 100% certain but it’s has 12.4 reading so guessing it’s ok
-
Paul-R
- Moderating Team
- Posts: 8959
- Joined: 07 May 2009, 16:24
- x 1855
Re: Electrical issues
Guessing isn't good enough. Neither is a static voltage reading.
Ideally a high end diagnostic reader needs to be used to find out what percentage of charge the battery is holding. This will be in the engine (sometimes called injection) ECU or the BSI I think.
Ideally a high end diagnostic reader needs to be used to find out what percentage of charge the battery is holding. This will be in the engine (sometimes called injection) ECU or the BSI I think.
As I get older I think a lot about the hereafter - I go into a room and then wonder what I'm here after.
Inside every old person is a young person wondering what the hell happened.
"Trying is the first step towards failure" ~ Homer J Simpson
Inside every old person is a young person wondering what the hell happened.
"Trying is the first step towards failure" ~ Homer J Simpson
-
Peugeot dan
- Posts: 3
- Joined: 28 Dec 2025, 11:33
Re: Electrical issues
There is a 5v reading at the boot latch loom so it’s not getting full voltage