DIAGBOX 9.68 MR RORRY
Moderator: RichardW
-
- Donor 2023
- Posts: 106
- Joined: 04 Aug 2022, 09:24
- x 1
Re: DIAGBOX 9.68 MR RORRY
Correction at acyclism on Injector 3 has always shown as a minus figure at Idle and as low/high as -65. I'm not sure what it means yet as I'm struggling to find the information.
-
- Donor 2023
- Posts: 106
- Joined: 04 Aug 2022, 09:24
- x 1
Re: DIAGBOX 9.68 MR RORRY
Before we get too bogged down in this, is it more likely that I simply need to upgrade to Win10 64 and use the v9 VM?
As I may be on the cusp between versions I could be chasing my tail, though so far, maybe this 7.76 is all I need, though finding a way to upgrade to 7.83 would also tick a box.
Thanks folks.
As I may be on the cusp between versions I could be chasing my tail, though so far, maybe this 7.76 is all I need, though finding a way to upgrade to 7.83 would also tick a box.
Thanks folks.
-
- Donor 2023
- Posts: 106
- Joined: 04 Aug 2022, 09:24
- x 1
Re: DIAGBOX 9.68 MR RORRY
Hi peeps, one last chime in b4 I finish for the night.
I have a few High readings from FAP pressure, going up to 300mbar......I've just read a generic article suggesting it should be around 180mbar at maximum, but not specific to this van.
Still not fault codes using DB but on my app there have been several suggesting Low Rail Pressure on Startup.
It's going to be another 9 months i think before I buy a merc and start all over again.
I have a few High readings from FAP pressure, going up to 300mbar......I've just read a generic article suggesting it should be around 180mbar at maximum, but not specific to this van.
Still not fault codes using DB but on my app there have been several suggesting Low Rail Pressure on Startup.
It's going to be another 9 months i think before I buy a merc and start all over again.