Blower motor- BX

chueewowee · Unread post by **chueewowee** » 31 Aug 2003, 19:33

Hi, http://www.andyspares.com/discussionfor ... e_dead.gif
My blower on the BX TDZ seems to be under par, though working. The heate rmatrix ahs been checked, and is ok. Any advice for troubleshooting and a fix?http://www.andyspares.com/discussionfor ... tongue.gif
Thanks,

Linegeist · Unread post by **Linegeist** » 31 Aug 2003, 22:19

Have you had a squint in the firewall compartment near the wiper motor?
If it's anything like mine, the 'filter' (it looks like a piece of old tights) which sits over the intake, was clogged with er, um, poo-poo!! (Can I say that?)
Clearing that lot took 20 seconds and was a worthwhile blow job.
regards
BC [:p]
Edited for a speelin mistakk!![:0]

tomsheppard · Unread post by **tomsheppard** » 01 Sep 2003, 02:28

Notor housing strips down easily enough. so does the motor. clean the commutator and rinse it in solvent. Let it dry. Reassemble and oil the motor. The two copper straps in the housing need a good clean and tighten. Allow an hour and a half. You will be amazed at the difference!