Electro guru needed

Unread post by **Richard Green** » 25 Jun 2005, 13:29

oh yes I have to agree with that ( voltage is a value ) current makes your hair stand up.

ghostrider · Unread post by **ghostrider** » 25 Jun 2005, 14:03

Most diodes will only put up with a certain voltage applied "the wrong way" after which they break down, can't remeber if they go short cicuit or open though.....
and hey who'd take a cit to the bottom of the sea, they rot quickly enough as it is [:D] [:D] [:D]
________
Zx14 vs hayabusa

Unread post by **martyhopkirk** » 25 Jun 2005, 14:10

<blockquote id="quote">quote:<hr height="1" noshade id="quote">Originally posted by Kowalski

Obviously the smoke seal's gone which is why the smoke came out.
<hr height="1" noshade id="quote"></blockquote id="quote">
Came to that conclusion a long time ago - electricity is really smoke as you never see any electricity, but when wires break down you always see smoke. Purchased a canister of smoke and some sealer to repair the cables on my BX.

bernie · Unread post by **bernie** » 27 Jun 2005, 15:49

<blockquote id="quote">quote:<hr height="1" noshade id="quote">Originally posted by tomsheppard

And if the original is short? Call me please, Bernie.
<hr height="1" noshade id="quote"></blockquote id="quote">
Sorry Tom, just noticed your post!!!!!
Been ill since Thursday[xx(][xx(][xx(][xx(]
It's nothing urgent as the HA2 valve actually snapped in two when I removed it and hopefully Andy (ActiveV6uk) is sending me some bits.
It's just in the wiring diagram there is a diode across the coil and I wondered how you would check the diode, electronic principals/rules etc.
So nothing urgent[:)]

tomsheppard · Unread post by **tomsheppard** » 27 Jun 2005, 16:35

You would use a scope and a sig gen and put in ac at a frequency high enough for the inductance of the coil to become a high impedance. The scope will now show half wave rectification if the diode is ok.

Kowalski · Unread post by **Kowalski** » 27 Jun 2005, 17:46

That's all that component tester I mentioned (way up at the top) is really, except that it was integrated and had multiple inputs and buttons to select the "right" frequency, amplitude and waveform for testing whatever you needed to.

bernie · Unread post by **bernie** » 27 Jun 2005, 18:34

That's exactly what I thought!!!!!!!!!!!!!!!!!!!!!!!!!!!!!??????????????????????????