RNEG Firmware or Software

[Samuelblue123]

Could I please get the download for the RT6 2.86.B version for my DS4?

[Paul-R]

I can't guarantee that it's the B variant but check your PM in a minute or two. Usual disclaimers, use at own risk, etc.

[roady1922]

Hi Paul, my RT6 in my C5 X7 is currently running firmware 2.77. Could you please send me the download link for the latest Firmware by PM? Thank you.

[Paul-R]

You've read all the warnings about moving to 2.86? About moving in steps rather than all at once? And how it is strongly advised to make a backup of your RT6 configuration with MiraScripts first?

[Issei]

Hello i retrofitted a rt6 (rneg) to my peugeot 308cc from 2009 wich had rd4 as original. Now i have time and date issue whenever the car goes to sleep mode it forgetts the time and date. according to ai a software update might solve it i run rneg 2.7.5.c and ai says to me to stop at rneg 2.8.0 can someone please give me a link to update it or at least bring some light to why it keeps dropping the time and date memory.

[Paul-R]

Not sure it'll fix your problem but check your PM in 5 minutes. Let us know how you get on.

[Mathys1pienaar]

Hi Paul. I noticed my situation is very similar to the situation written on the Tutorial on how to replace your SD card of a RT6 unit, where my screen is blank with no audio after using one of the 2.86B versions found on the internet, It reads and starts the installation, gives me an installation percentage twice, restarts and then just restarts the whole installation process over again. My SD card that came with the car would not read on computer, so i am assuming that it failed completely, So I had no way of using Mirascripts. Could you please assist me with a download link for this system for 2.86(or newer) so that I can test the RT6 with a version that would more likely be an actual working version?

[Issei]

Not sure it'll fix your problem but check your PM in 5 minutes. Let us know how you get on.

Hi you are right it did not fix my issue. But i did solve it by adding a permanent 12v to the power wire i took the same 12v from the previous screen when i had a rd4 radio. So far everything seems to work both of my aftermarket amps are shutting down. The real test will be tomorrow when i start the car will it be dead or will it start nobody knows

[Paul-R]

@Mathys1pienaar

Check your PM in five minutes.