Irratic Oil Level on dashboard

[Mickey_London]

Hi, new here, be gentle
On my 2019 Relay 2.2 I keep getting a Warning Triangle on the dashboard
Now....
If I switch off the ignition and wiggle the wire going to the Oil Pressure and Temperature sensor, then switch on the ignition I get the Oil Level with the dots appear and the warning triangle then goes out like normal.
Then after a couple of start ups the triangle stays on again, so under I go and wiggle the wires

This happens all the time. Anyone else had this issue.

Thanks for any reply
Mick

[Paul-R]

You need to get the car read for error codes (DTCs) with a high end code reader, preferably Diagbox. This will give a better idea of what might be wrong.

[Mickey_London]

Hi Paul
Thanks for the reply
I have had it scanned with an AutoLink Autel scanner and Konnwei scanner, not sure how good they are but look expensive haha
It is not throwing up any codes
Mick

[Mihael_M]

You should check the oil level manually. The fact that you wave the wire and then change the status means that you have a problem with the connector. Probably the connector is dirty or rusted.

[Mickey_London]

The oil level is fine on the dipstick
Just wondered why when I move the wire to the oil pressure switch it then shows the oil level on the dash and the warning triangle goes out. The oil level sensor, I beleive, is on the otherside of the engine, can't see how they would be connected.

Anyway, I have some electrical contact cleaner coming today, see if that works
These modern cars do funny things I suppose haha

Thanks for all replies
Appreciated
Mick