Expert 1.6 HDi 2010 ebd2 wiring has been ripped out.

[Gazfoz]

Hi, My Expert has gone into limp mode but i cannot plug into it to diagnose the problem. The wires have been ripped out of the connector. i have trawled the internet looking for wiring diagrams, photos or youtube
but nothing for the MK2. Would anyone on this forum with an Expert the same as mine be able to help with a couple of photo's or even a wiring diagram as i am at a loss what to do next.
Many Thanks..

[GiveMeABreak]

First of all, pop your VIN up for us so we can see if we have the correct wiring diagram.

[Gazfoz]

VIN: VF3**************[VIN obfuscated, can be read by forum staff]

[GiveMeABreak]

Ok so I hope this will help. Commercial vans are numerous and it's not always easy to select the correct one, but I believe this to be the one for your vehicle.

The Diagnostic Port is C001 on the diagram.

Wires

ME01 : electronic earth 01
MC001 is your body earth.
9028 : diagnostic high CAN bus (BSI)
9029 : diagnostic low CAN bus (BSI)
9001B : Low Intersystem / Can bus
9000B : High Intersystem / Can bus
BE01 is your battery positive
CNC00 is the ignition controlled positive

[Gazfoz]

Wow that was quick, looks pretty much there to me.
There is one more wire, cream or beige in colour 90006,23 03 marked on it?
Many Thanks again, Ive been at this since Thursday.

[GiveMeABreak]

No worries

I don't have that wire showing, but a look up says:

9006 : Diagnostic line bus K (engine + automatic gearbox management)

Hope that helps.