As title says, what's best for cleaning Block paving and any tips to slow down or stop weeds growing.?
Please
Cleaning Block paving - what's best
Moderator: RichardW
- Sloppysod
- Donor 2024
- Posts: 1003
- Joined: 23 May 2015, 23:35
- Location: North Wales
- My Cars: Citroens
1 x GS, 1 x GSX (Banger raced), 1 x GSA,
2 x CX Famililles, 1 x CX GTI,
BX, XM, Xantia, C5 Mk1,
C4 (Coupe), C4 (B7),
C5 (X7) - RIP April 2024
Renault
R4 Van
Fuego
Clio Campas - x 216
Cleaning Block paving - what's best
Stu
"Some cause happiness wherever they go, others whenever they go"Oscar Wilde (1854-1900)
Major interventions
C5 Steering rack @ 58,000 mi
4 discs & Pads @ 63,585 mi
2 (AM6) oil exchanges @ 58,876 & 72,378 mi
"Some cause happiness wherever they go, others whenever they go"Oscar Wilde (1854-1900)
Major interventions
C5 Steering rack @ 58,000 mi
4 discs & Pads @ 63,585 mi
2 (AM6) oil exchanges @ 58,876 & 72,378 mi
- GiveMeABreak
- Forum Admin Team
- Posts: 37408
- Joined: 15 Sep 2015, 19:38
- Location: West Wales
- My Cars: C3 Aircross SUV HDi Flair Peperoncino Red (The Chili Hornet)
C5 X7 2.0 HDi Exclusive Mativoire Beige (The Golden Hornet)
C3 1.6 HDi Exclusive Aluminium Grey (The Silver Hornet)
C5 MK II 2.0 HDi Exclusive Obsidian Black
C5 MK I 2.0 HDi SX Wicked Red
Xantia S2 2.0 HDi SX Hermes Red
C15 Romahome White
XM 2.0 Turbo Prestige Emerald Green Pearlescent
XM 2.0 Turbo Prestige Polar White
XM 2.0 SX Polar White
CX 20 Polar White
GS 1220 Geranium Red
CX 2.4 Prestige C-Matic Nevada Beige
GS 1000 Cedreat Yellow - x 5741
Re: Cleaning Block paving - what's best
I use my Karcher pressure washer with patio attachment. It cleans up ant stone or concrete brilliantly. Just make sure there are no loose stones or hard debris in the way.
Please Don't PM Me For Technical Help
Marc
Marc
- Sloppysod
- Donor 2024
- Posts: 1003
- Joined: 23 May 2015, 23:35
- Location: North Wales
- My Cars: Citroens
1 x GS, 1 x GSX (Banger raced), 1 x GSA,
2 x CX Famililles, 1 x CX GTI,
BX, XM, Xantia, C5 Mk1,
C4 (Coupe), C4 (B7),
C5 (X7) - RIP April 2024
Renault
R4 Van
Fuego
Clio Campas - x 216
Re: Cleaning Block paving - what's best
Thanks Marc, I use my jet wash with a similar device attached, but seems to waste alot of water for little improvement.
My pavers are permeable, thought it was a good idea at the time, so as to allow water to pass through rather than run off and create a slippery hill I can the winter. . . .
My pavers are permeable, thought it was a good idea at the time, so as to allow water to pass through rather than run off and create a slippery hill I can the winter. . . .
Stu
"Some cause happiness wherever they go, others whenever they go"Oscar Wilde (1854-1900)
Major interventions
C5 Steering rack @ 58,000 mi
4 discs & Pads @ 63,585 mi
2 (AM6) oil exchanges @ 58,876 & 72,378 mi
"Some cause happiness wherever they go, others whenever they go"Oscar Wilde (1854-1900)
Major interventions
C5 Steering rack @ 58,000 mi
4 discs & Pads @ 63,585 mi
2 (AM6) oil exchanges @ 58,876 & 72,378 mi
- bobins
- Donor 2023
- Posts: 5739
- Joined: 05 Jul 2012, 18:07
- Location: Midhurst, West Sussex
- My Cars: Kia Sportage
Mazda BT-50
Land Rover SIII SWB
V-F-R800
SL320
MX5 - x 2892
Re: Cleaning Block paving - what's best
If it's because the paving has gone a bit black or green due to moss and/or algae growing in damp conditions then the following does not constitute advice or recommendation.......
Apparently Benzalkonium Chloride - commonly sold as BAC50 - diluted down to 2-3% solution and applied on the hard surfaces with a watering can is good at killing off moss and algae and keeping it killed for many many months. However, it's use for this cannot be recommended as if used incorrectly or poorly or by knobheads it can cause damage It should not be allowed to get into waterways (streams, ditches, ponds etc) - no ifs, no buts. It should only be used once a year - no ifs, no buts. It's only good for hard surfaces - not lawns. BAC50 is used in an awful lot of common stuff - from bathroom mold removers, to some contact lens solutions, to hospital cleaners, etc, etc. It's not actually dangerous per-se, it's just it should be used by sensible people. You wouldn't go pouring bleach into a stream - and the same goes for BAC50. BAC50 is actually the main ingredient in a lot of moss and algae removers, it's just that it's mixed in with a lot of other things at the same time.
Once the BAC50 has done its job - a couple/few days should suffice - then a good pressure washing with a 'turbo' nozzle should clean the paving up nicely, assuming you've not got a sand infill Don't do it when it's scorching hot as it'll evaporate too quickly, and it might pay to wet the paving before you start. The moss and algae will give off an 'aroma' as it keels over
If the paving is just dirty, then don't bother with the bAC50 as it won't really help.
As for keeping the weeds down, good residual weedkillers for hard surfaces are few and far between these days. Ones for commercial use are fairly expensive and fairly restrictive on their usage, but for 'back garden' use you might want to look into 'Pathclear' weedkiller, though there are restrictions on its use as well It should be OK to use if you've got sand infill block paving, but not really recommended if it's an impermeable infill.
Read the instructions !!
Apparently Benzalkonium Chloride - commonly sold as BAC50 - diluted down to 2-3% solution and applied on the hard surfaces with a watering can is good at killing off moss and algae and keeping it killed for many many months. However, it's use for this cannot be recommended as if used incorrectly or poorly or by knobheads it can cause damage It should not be allowed to get into waterways (streams, ditches, ponds etc) - no ifs, no buts. It should only be used once a year - no ifs, no buts. It's only good for hard surfaces - not lawns. BAC50 is used in an awful lot of common stuff - from bathroom mold removers, to some contact lens solutions, to hospital cleaners, etc, etc. It's not actually dangerous per-se, it's just it should be used by sensible people. You wouldn't go pouring bleach into a stream - and the same goes for BAC50. BAC50 is actually the main ingredient in a lot of moss and algae removers, it's just that it's mixed in with a lot of other things at the same time.
Once the BAC50 has done its job - a couple/few days should suffice - then a good pressure washing with a 'turbo' nozzle should clean the paving up nicely, assuming you've not got a sand infill Don't do it when it's scorching hot as it'll evaporate too quickly, and it might pay to wet the paving before you start. The moss and algae will give off an 'aroma' as it keels over
If the paving is just dirty, then don't bother with the bAC50 as it won't really help.
As for keeping the weeds down, good residual weedkillers for hard surfaces are few and far between these days. Ones for commercial use are fairly expensive and fairly restrictive on their usage, but for 'back garden' use you might want to look into 'Pathclear' weedkiller, though there are restrictions on its use as well It should be OK to use if you've got sand infill block paving, but not really recommended if it's an impermeable infill.
Read the instructions !!
Sadly no longer a C5 owner
- white exec
- Moderating Team
- Posts: 7445
- Joined: 21 Dec 2015, 12:46
- Location: Sayalonga, Malaga, Spain
- My Cars: 1996 XM 2.5TD Exclusive hatch RHD
1992 BX19D Millesime hatch LHD
previously 1989 BX19RD, 1998 ZX 1.9D auto, 2001 Xantia 1.8i auto
and lots of Rovers before that: 1935 Ten, 1947 Sixteen, 1960 P5 3-litre, 1966 P6 2000, 1972 P6 2000TC, and 1975 P6B 3500S - x 1752
Re: Cleaning Block paving - what's best
Another vote for a jet-washer, with turbo lance (which minimises water usage).
We have a good bit of terracotta tiled pathway - very porous, and not a lot different from a coarse flowerpot (the worst kind ). The jet-wash chases all the blackening out. Just be careful with any poor grouting.
We have a good bit of terracotta tiled pathway - very porous, and not a lot different from a coarse flowerpot (the worst kind ). The jet-wash chases all the blackening out. Just be careful with any poor grouting.
Chris
- GiveMeABreak
- Forum Admin Team
- Posts: 37408
- Joined: 15 Sep 2015, 19:38
- Location: West Wales
- My Cars: C3 Aircross SUV HDi Flair Peperoncino Red (The Chili Hornet)
C5 X7 2.0 HDi Exclusive Mativoire Beige (The Golden Hornet)
C3 1.6 HDi Exclusive Aluminium Grey (The Silver Hornet)
C5 MK II 2.0 HDi Exclusive Obsidian Black
C5 MK I 2.0 HDi SX Wicked Red
Xantia S2 2.0 HDi SX Hermes Red
C15 Romahome White
XM 2.0 Turbo Prestige Emerald Green Pearlescent
XM 2.0 Turbo Prestige Polar White
XM 2.0 SX Polar White
CX 20 Polar White
GS 1220 Geranium Red
CX 2.4 Prestige C-Matic Nevada Beige
GS 1000 Cedreat Yellow - x 5741
Re: Cleaning Block paving - what's best
Yes the water used is not as bad as you would think to be honest.
As for algae killer, I use the Pro-Kleen stuff that you dilute with water - great for keeping the water in water features algae free - as long as you don't have fish in there of course....
As for algae killer, I use the Pro-Kleen stuff that you dilute with water - great for keeping the water in water features algae free - as long as you don't have fish in there of course....
Please Don't PM Me For Technical Help
Marc
Marc