Hi all, I've just joined the forum in the hope that someone may be able to help me. In October 2019 I purchased my lovely 2012 5008 1.6HDI. Despite a few minor issues it's been a great car so far, one niggly issue is my EGR valve is showing a "fail" on OBD reading but the car 99% of the time is perfectly fine with the occasional little bit of throttle resistance through the lower revs.
Is this a normal thing to go on the 5008? How easy is the egr valve to find and clean for someone with a limited 'new car' mechanical knowledge... I used to work on the fords from back in the day doing most things myself as I'm sure did a lot of others!
Any help or advice will be kindly received
Newbie EGR question
Moderator: RichardW
-
- Donor 2023
- Posts: 13745
- Joined: 01 Apr 2012, 09:47
- Location: Reading
- My Cars: C5 Mk2 VTX+ estate.
- x 3008
Re: Newbie EGR question
Hello, and to the Forum.
What make is your OBD reader? Most generic code readers don't work well (if at all) with the PSA vehicles, and a specific reader is needed (commonly known as either a Lexia or a DiagBox system). This is an item of hardware (with the relevant cables and software) which is used in conjunction with a PC (preferably a laptop, for the mobility) to get far more information and control of the connected vehicle.
What make is your OBD reader? Most generic code readers don't work well (if at all) with the PSA vehicles, and a specific reader is needed (commonly known as either a Lexia or a DiagBox system). This is an item of hardware (with the relevant cables and software) which is used in conjunction with a PC (preferably a laptop, for the mobility) to get far more information and control of the connected vehicle.
James
ex BX 1.9
ex Xantia 2.0HDi SX
ex Xantia 2.0HDi LX
Ex C5 2.0HDi VTR
Ex C5 2.0HDi VTR
C5 2.2HDi VTX+
Yes, I am paranoid, but am I paranoid ENOUGH?
Out amongst the stars, looking for a world of my own!
ex BX 1.9
ex Xantia 2.0HDi SX
ex Xantia 2.0HDi LX
Ex C5 2.0HDi VTR
Ex C5 2.0HDi VTR
C5 2.2HDi VTX+
Yes, I am paranoid, but am I paranoid ENOUGH?
Out amongst the stars, looking for a world of my own!
-
- Posts: 3
- Joined: 10 Feb 2020, 09:41
- Location: Margate
- My Cars: 2012 Peugeot 5008
2010 Renault grand scenic
Re: Newbie EGR question
Hi Razor,
Thank you for the reply I apologise for the delayed response...
It was an Amazon £20 special jobby - Launch 3001, it read all codes and gave me live info following a battery change but showed said EGR failure on its readings. However Its since been sent back as the display died.
My car as I say runs great generally, no smoke whatsoever, pulls really well and only has 52kon the clock so I wouldn't expect it to be clogged but that reading and occasional throttle resistance has perturbed me!
Would you be in a position to share whereabouts the egr would be?
Thank you for the reply I apologise for the delayed response...
It was an Amazon £20 special jobby - Launch 3001, it read all codes and gave me live info following a battery change but showed said EGR failure on its readings. However Its since been sent back as the display died.
My car as I say runs great generally, no smoke whatsoever, pulls really well and only has 52kon the clock so I wouldn't expect it to be clogged but that reading and occasional throttle resistance has perturbed me!
Would you be in a position to share whereabouts the egr would be?
- GiveMeABreak
- Forum Admin Team
- Posts: 37403
- Joined: 15 Sep 2015, 19:38
- Location: West Wales
- My Cars: C3 Aircross SUV HDi Flair Peperoncino Red (The Chili Hornet)
C5 X7 2.0 HDi Exclusive Mativoire Beige (The Golden Hornet)
C3 1.6 HDi Exclusive Aluminium Grey (The Silver Hornet)
C5 MK II 2.0 HDi Exclusive Obsidian Black
C5 MK I 2.0 HDi SX Wicked Red
Xantia S2 2.0 HDi SX Hermes Red
C15 Romahome White
XM 2.0 Turbo Prestige Emerald Green Pearlescent
XM 2.0 Turbo Prestige Polar White
XM 2.0 SX Polar White
CX 20 Polar White
GS 1220 Geranium Red
CX 2.4 Prestige C-Matic Nevada Beige
GS 1000 Cedreat Yellow - x 5741
Re: Newbie EGR question
Post your VIN up and I'll get a diagram once we know the exact engine type. But before you start doing anything with the EGR, I really would advise a proper diagnostic. Generic aftermarket readers cannot read constructor-specific fault codes - only the basic EOBD codes with often very little else. Once you have the codes put them up here and we can advise on the fault.Space2308 wrote: ↑10 Feb 2020, 11:51 Hi all, I've just joined the forum in the hope that someone may be able to help me. In October 2019 I purchased my lovely 2012 5008 1.6HDI. Despite a few minor issues it's been a great car so far, one niggly issue is my EGR valve is showing a "fail" on OBD reading but the car 99% of the time is perfectly fine with the occasional little bit of throttle resistance through the lower revs.
Is this a normal thing to go on the 5008? How easy is the egr valve to find and clean for someone with a limited 'new car' mechanical knowledge... I used to work on the fords from back in the day doing most things myself as I'm sure did a lot of others!
Any help or advice will be kindly received
Please Don't PM Me For Technical Help
Marc
Marc
-
- Forum Treasurer
- Posts: 10890
- Joined: 07 Aug 2002, 17:12
- Location: United Kingdom
- My Cars: MK2 '17 C4GP 1.6 BlueHDi 120
'13 3008 1.6 HDi GripControl - x 1002
Re: Newbie EGR question
On the 1.6 diesels it is down the back of the engine, LH side of the car. Exact type will depend on engine, I expect this is a DV6C. If the EML is not on, then I would ignore it....
Richard W
-
- Posts: 3
- Joined: 10 Feb 2020, 09:41
- Location: Margate
- My Cars: 2012 Peugeot 5008
2010 Renault grand scenic
Re: Newbie EGR question
Thanks all for the replies, I will get my vin shortly and post it up... much appreciated