Hey Guys need a quick answer if possible please.
Last week I had a front brake wear warning light come up on the dash. Booked the car in for some new pads over the weekend, no problems.
Got a phonecall from the garage on Saturday, Pads are fine loads left on them, but there was too much water in the brake fluid, they reckoned there is a good chance the fluid was freezing up in the cold. So they flushed it out and refilled it. However this morning I'm getting the same light again.
Any ideas as to what it could be? I'll be ringing the garage at lunchtime, but would like some ideas first if possible.
Car is a 51 plate 406 2.0 HDi 90 Estate.
Cheers in advance.
Brake Warning Light
-
OwenP
- Posts: 308
- Joined: 31 Jul 2004, 19:05
Brake Warning Light
2001 406 Rapier 2.0 HDi 90 Estate - Sold Scrap after being viciously attacked by a falling tree
2001 Toyota MR2 1.8 VVTi - To be sold for spares/repair - dead gearbox
2014 Seat Ibiza Eastate 1.4 FR ACT (bought in an emergency, but a nice enough low mileage car)
2001 Toyota MR2 1.8 VVTi - To be sold for spares/repair - dead gearbox
2014 Seat Ibiza Eastate 1.4 FR ACT (bought in an emergency, but a nice enough low mileage car)
-
spider
- Posts: 3949
- Joined: 05 Jan 2010, 14:28
- x 77
Re: Brake Warning Light
Is it actually the fluid warning or the wear warning ?
Fluid level / Handbrake also is red, pad warning is amber. If its amber, suspect the pad warning wire is chafing somewhere not uncommon.
Problems with the handbrake switch can cause this fluid level to come on intermittently too along with the display stating fluid level.
Fluid level / Handbrake also is red, pad warning is amber. If its amber, suspect the pad warning wire is chafing somewhere not uncommon.
Problems with the handbrake switch can cause this fluid level to come on intermittently too along with the display stating fluid level.
Andy.
91 205D-Turbo, gone but still missed
02 106D, TUD5B, gone but not really missed apart from the MPG
91 205D-Turbo, gone but still missed
02 106D, TUD5B, gone but not really missed apart from the MPG
-
OwenP
- Posts: 308
- Joined: 31 Jul 2004, 19:05
Re: Brake Warning Light
The warning is an amber circle with 3 curved dashes on either side of it.
If it is just the wire is that an easy fix (bit of electrical tape or the like), or is it a convoluted job?
Cheers
If it is just the wire is that an easy fix (bit of electrical tape or the like), or is it a convoluted job?
Cheers
2001 406 Rapier 2.0 HDi 90 Estate - Sold Scrap after being viciously attacked by a falling tree
2001 Toyota MR2 1.8 VVTi - To be sold for spares/repair - dead gearbox
2014 Seat Ibiza Eastate 1.4 FR ACT (bought in an emergency, but a nice enough low mileage car)
2001 Toyota MR2 1.8 VVTi - To be sold for spares/repair - dead gearbox
2014 Seat Ibiza Eastate 1.4 FR ACT (bought in an emergency, but a nice enough low mileage car)
-
spider
- Posts: 3949
- Joined: 05 Jan 2010, 14:28
- x 77
Re: Brake Warning Light
If its the amber light its pad wear this one >>>
(( O )) , more or less
The (!) is red and brake fluid / handbrake.
Yes, it should be straightforward, I bet its just rubbed though. Take the front wheels off (might not be needed, try full lock each way) and look at the pad wear wire, you'll see it it sometimes has a connector on the strut itself and a single wire (per pad if all four,usually only two though) to the caliper.
I threw mine away as they rubbed though. The ABS wiring will be nearby although you should not confuse it too easily with that.
Could not find you a pic unfortunately.
(( O )) , more or less
The (!) is red and brake fluid / handbrake.
Yes, it should be straightforward, I bet its just rubbed though. Take the front wheels off (might not be needed, try full lock each way) and look at the pad wear wire, you'll see it it sometimes has a connector on the strut itself and a single wire (per pad if all four,usually only two though) to the caliper.
I threw mine away as they rubbed though. The ABS wiring will be nearby although you should not confuse it too easily with that.
Could not find you a pic unfortunately.
Andy.
91 205D-Turbo, gone but still missed
02 106D, TUD5B, gone but not really missed apart from the MPG
91 205D-Turbo, gone but still missed
02 106D, TUD5B, gone but not really missed apart from the MPG
-
OwenP
- Posts: 308
- Joined: 31 Jul 2004, 19:05
Re: Brake Warning Light
OK now this is getting wierd, I drove home tonight with no warning lights at all.
If the wire was rubbing through I would expect it to be a continuous fault.
So I'm left with possibly: an intermittent wire problem (I will check this later anyway, might be lunch time at work tomorrow though in the daylight)
An intermittent fault with the sensor.
Some sort of temperature dependant issue (ie cold in the morning being a problem)
I will have to see if it comes on in the same place tomorrow morning as it did this morning.
If the wire was rubbing through I would expect it to be a continuous fault.
So I'm left with possibly: an intermittent wire problem (I will check this later anyway, might be lunch time at work tomorrow though in the daylight)
An intermittent fault with the sensor.
Some sort of temperature dependant issue (ie cold in the morning being a problem)
I will have to see if it comes on in the same place tomorrow morning as it did this morning.
2001 406 Rapier 2.0 HDi 90 Estate - Sold Scrap after being viciously attacked by a falling tree
2001 Toyota MR2 1.8 VVTi - To be sold for spares/repair - dead gearbox
2014 Seat Ibiza Eastate 1.4 FR ACT (bought in an emergency, but a nice enough low mileage car)
2001 Toyota MR2 1.8 VVTi - To be sold for spares/repair - dead gearbox
2014 Seat Ibiza Eastate 1.4 FR ACT (bought in an emergency, but a nice enough low mileage car)
-
spider
- Posts: 3949
- Joined: 05 Jan 2010, 14:28
- x 77
Re: Brake Warning Light
The sensor is just usually a brass ended wire that gets earthed to bring the light on, nothing else. 
It earths through the pads / disc when the pads reach a min thickness the wire becomes in contact with the discs hence the light. Favourite break point is probably just after the plug on the shock, although I'd not be surprised to find one adrift. It should only put the light on if its making contact, rather than vice versa (iirc Fords actually need the contact to keep the light off) , the wire is somtimes part of the pad sometimes it comes with them and you just plug in both ends.
Its very simple.
12v supply > bulb in instrument panel > wire to pads > earth (disc) when pads worn.
Here is a picture I found > http://www.ebay.co.uk/itm/PEUGEOT-406-B ... 0229049155" onclick="window.open(this.href);return false; (nothing to do with me) , note the wires on the front pads, one wire per side.
It earths through the pads / disc when the pads reach a min thickness the wire becomes in contact with the discs hence the light. Favourite break point is probably just after the plug on the shock, although I'd not be surprised to find one adrift. It should only put the light on if its making contact, rather than vice versa (iirc Fords actually need the contact to keep the light off) , the wire is somtimes part of the pad sometimes it comes with them and you just plug in both ends.
Its very simple.
12v supply > bulb in instrument panel > wire to pads > earth (disc) when pads worn.
Here is a picture I found > http://www.ebay.co.uk/itm/PEUGEOT-406-B ... 0229049155" onclick="window.open(this.href);return false; (nothing to do with me) , note the wires on the front pads, one wire per side.
Andy.
91 205D-Turbo, gone but still missed
02 106D, TUD5B, gone but not really missed apart from the MPG
91 205D-Turbo, gone but still missed
02 106D, TUD5B, gone but not really missed apart from the MPG
-
Peter.N.
- Moderating Team
- Posts: 11779
- Joined: 02 Apr 2005, 16:11
- x 1240
Re: Brake Warning Light
Its not unusual for them to be imtermittent, if the pads are OK I shouldn't worry about it, they probably don't work on 50% of old cars anyway.
Peter
Peter
-
OwenP
- Posts: 308
- Joined: 31 Jul 2004, 19:05
Re: Brake Warning Light
I hadn't realised the sensor was as simple as that!
Makes it much easier to deal with then. I tried to have a look at work this morning, but couldn't really see anything. So I'll have a look over the weekend with the wheels off.
Warning light hasn't come on again since I posted this, so I'm not too concerned, although I will have a look through the new MOT stuff regarding warning lights as sods law says it'll cause a problem on the MOT even if it doesn't at any other time!
Makes it much easier to deal with then. I tried to have a look at work this morning, but couldn't really see anything. So I'll have a look over the weekend with the wheels off.
Warning light hasn't come on again since I posted this, so I'm not too concerned, although I will have a look through the new MOT stuff regarding warning lights as sods law says it'll cause a problem on the MOT even if it doesn't at any other time!
2001 406 Rapier 2.0 HDi 90 Estate - Sold Scrap after being viciously attacked by a falling tree
2001 Toyota MR2 1.8 VVTi - To be sold for spares/repair - dead gearbox
2014 Seat Ibiza Eastate 1.4 FR ACT (bought in an emergency, but a nice enough low mileage car)
2001 Toyota MR2 1.8 VVTi - To be sold for spares/repair - dead gearbox
2014 Seat Ibiza Eastate 1.4 FR ACT (bought in an emergency, but a nice enough low mileage car)
-
spider
- Posts: 3949
- Joined: 05 Jan 2010, 14:28
- x 77
Re: Brake Warning Light
Until it changes the pad wear light is not a failure, or it was not. The red fluid level one is obviously. 
The pad wear will probably merit a comment on the advisory sheet (non testable items) though I'd guess.
The pad wear will probably merit a comment on the advisory sheet (non testable items) though I'd guess.
Andy.
91 205D-Turbo, gone but still missed
02 106D, TUD5B, gone but not really missed apart from the MPG
91 205D-Turbo, gone but still missed
02 106D, TUD5B, gone but not really missed apart from the MPG