Silicone sealant and LHM

HDI · Unread post by **HDI** » 26 Jan 2010, 22:22

lexi wrote:Whenever the word Fluro comes up I smile. Many tests have been done on "flurocarbon" fishing line and basically they are a rip off in price and what they are supposed to be in the actual term fluro. Some tests said it was line with soap on it.
Afaik there are no fluro silicones in a tube. I think they are manufacturer extruded into shape?

Rubbers are interesting

I did say similar to

There are flurosilicone sealants , but not generally available.

lexi · Unread post by **lexi** » 26 Jan 2010, 22:30

Two pages on silicone rubber and nobodys mentioned Breast Augmentation ?

Xaccers · Unread post by **Xaccers** » 26 Jan 2010, 22:51

lexi wrote:Two pages on silicone rubber and nobodys mentioned Breast Augmentation ?

Malcolm's probably busy

Unread post by **Paul-R** » 26 Jan 2010, 23:19

lexi wrote:Two pages on silicone rubber and nobodys mentioned Breast Augmentation ?

Not until you!!

Unread post by **Dommo** » 03 Feb 2010, 15:22

Little update. I did get around to opening the tube of sealant I have, it does have the vinegar smell to it.

I dolloped some onto a surface, let it set slightly, then put it in a bottle cap with LHM in. Just went to have a look and the silicone looks in the same shape as before but the LHM does smell of vinegar, a bad sign?

Thanks.

lexi · Unread post by **lexi** » 03 Feb 2010, 18:05

If you had let silicone cure before exposing to LMM the smell may not have been there and the silicone is then more stable. 48hrs depending on temp and thickness of bead.

Even two part Polysulphide takes 7 days to fully cure .

Unread post by **Dommo** » 03 Feb 2010, 18:16

In that case am I best sealing it up then leaving it for a few days before I turn the car on? There shouldn't be much if any LHM in the ram at the moment, as I've had the Activa sphere block/electrovalve out.

Cheers.