Some garages......

This is the Forum for all your Citroen Technical Questions, Problems or Advice.
vince
Posts: 1409
Joined: 22 May 2008, 22:29
x 13

Some garages......

Unread post by vince »

I had a guy call in today with a HDI Synergie asking for the price of a complete new radiator fan assembly.

When i asked him "why whats your car doing"? he replied that his fans werent kicking in. The garage he took it to dont know what the fault is so advised him to just replace the fans..... :?

I asked him if they had run a positive feed to the fans to see if there is a feed problem and he said no. He seemed slightly relieved at the possibility it could be a feed fault and perhaps fixed for a few quid...I often find that garages break out in a rash when a Citroen is thrown into the mix :roll: Poor customers start having kittens with some of the advice they get. Almost like the guy who was told he needed a complete new rear axle for a C5 when he just needed the rear bearings done :lol:


Stick to a good independant specialist :wink:
1993 Citroen xm 2.1td, silver/grey, bowling ball wheel trims, 210k and climbing...
citroenxm
Fallen Hero
Posts: 8061
Joined: 30 Dec 2004, 23:10
x 70

Unread post by citroenxm »

PRECISLEY why a lot of people get rid of their cars prematurley, because the lesser "mechanics" who haven't got a clue about Citroens give the wrong advice and they then the owners run a mile!!!

A GREAT SHAME!!!

Paul
Sharing a pug 207 1.6 hdi Sw 16v.
M reg Xm 2.1 td auto exclusive S2 269k and rising
L reg XM V6 12v SEi auto .. Light project

A very sad...
1994 XM 2.1 d auto
admiral51
(Donor 2026)
Posts: 2681
Joined: 24 May 2007, 10:11
x 391

Unread post by admiral51 »

To be honest i dont think this is just a Citroen problem although it may be more prevalent with them due to their "quirkiness" as percieved by the general public :( :(
Im only 42 but i can remember being at school in the early 80's when computers (BBC/ZX81/Oric/Commodore) were becoming more available and i did take a passing interest but only as a pastime :) :)
At the time i had a Ford Cortina MK2 and can remember changing/replacing the piston rings and big ends/reseating the valves(got loads of splinters :lol: )with the help of my Dad and the car was off the road for 36 hours :D :D
Nowadays i think we live in a throw away society where everything is electronically controlled and unless you have the "expertise" to do the job yourself(self belief :) ) then you trust the "experts" :x :x
A little knowledge goes a long way but i think the younger mechanics of today have never been brought up to "feel" whats wrong with a car they just plug it in and get a result,they dont have the savvy to question the result with any degree of logic ie the original post.....computer says fans not working...replace ...not find out why they are not working :evil: :evil:

Sorry if this is a bit of a rant but my mechanical/electrical skills are very limited(HGV Driver dont get paid to think just drive :lol: :lol: ) but just an honest opinion

Colin
Peter.N.
Moderating Team
Posts: 11777
Joined: 02 Apr 2005, 16:11
x 1240

Unread post by Peter.N. »

The same thing has happened to my trade. I have been a TV engineer for over 50 years, in the early days you could and did fix everything, then came transistors which I slowly got to grips with, and then IC's, at this point there is no way you can tell whats going on so fault diagnosis is mostly guesswork, the difference with TV repairs is that you couldn't charge the cutomer unless you found the fault! Many hours were wasted, as the sets became more complicated the viability of repairing them decreased. I dont understand the new sets at all and wouldn't attempt to repair one, or at least, not witout a very comprehensive service manual.

Peter
ACTIVE8
Posts: 2317
Joined: 16 Nov 2004, 16:49
x 6

Unread post by ACTIVE8 »

admiral51 wrote:To be honest i dont think this is just a Citroen problem although it may be more prevalent with them due to their "quirkiness" as percieved by the general public :( :(
Im only 42 but i can remember being at school in the early 80's when computers (BBC/ZX81/Oric/Commodore) were becoming more available and i did take a passing interest but only as a pastime :) :)
At the time i had a Ford Cortina MK2 and can remember changing/replacing the piston rings and big ends/reseating the valves(got loads of splinters :lol: )with the help of my Dad and the car was off the road for 36 hours :D :D
Nowadays i think we live in a throw away society where everything is electronically controlled and unless you have the "expertise" to do the job yourself(self belief :) ) then you trust the "experts" :x :x
A little knowledge goes a long way but i think the younger mechanics of today have never been brought up to "feel" whats wrong with a car they just plug it in and get a result,they dont have the savvy to question the result with any degree of logic ie the original post.....computer says fans not working...replace ...not find out why they are not working :evil: :evil:

Sorry if this is a bit of a rant but my mechanical/electrical skills are very limited(HGV Driver dont get paid to think just drive :lol: :lol: ) but just an honest opinion

Colin
So these experts will get even worse, & what with different cars like Citroens confusing them, & with the complexity level, & the consumers expectations going higher & higher the future looks.........so good not!

Looks like we could be heading for........the throwaway car, perish the thought, & scrappage is not helping this, even causing some classics to get scrapped. :evil:
ACTIVA

The car that looks like a family car, but has special secret hidden abilities.
Peter.N.
Moderating Team
Posts: 11777
Joined: 02 Apr 2005, 16:11
x 1240

Unread post by Peter.N. »

That's one of the primary reasons I run XMs, my estates were all registered in Jan '96, the last model with fully mechanical fuel injection, I have found nothing yet that I can't repair or replace myself. I couldn't live with a car that I had to take to a garage every time it went wrong or that would stop for no apparant reason and needed a computer to restart it. I think that the best cars for reliability and durability were made in the mid '90s
addo
Sara Watson's Stalker
Posts: 7098
Joined: 19 Aug 2008, 12:38
x 95

Unread post by addo »

I tend to agree! The biggest shortcomings are skin panel thickness (a little thin) minimum spec cabling and obsolete plastic bits.
citronut
Posts: 10937
Joined: 29 Apr 2005, 00:46
x 94

Unread post by citronut »

Activa8 wrote
" & what with different cars like Citroens confusing them, & with the complexity"


trouble is CITROEN's are becomeing more like run of the mill EURO box's, and loosing there identity,

i think every one should drive a dersh (points/condensor and carb's, and you can even lift the engine out without liftting tackle

regards malcolm
Peter.N.
Moderating Team
Posts: 11777
Joined: 02 Apr 2005, 16:11
x 1240

Unread post by Peter.N. »

... or something with an XUD engine. :D