peugeot front bumper

grattsim · Unread post by **grattsim** » 16 Aug 2007, 10:57

Can someone give me some advice on removing the front bumper of my 306 D Turbo. (1999)
Is it just a matter of removing the wheel arch liners and losening the brackets. Are there other larger bolts holding it on? If so where would I find these. What else am I likely to have to remove?
All this to change a fog light.... Any guidance would be appriciated. Thanks

caveman_si · Unread post by **caveman_si** » 16 Aug 2007, 17:48

Dont know what it is like on the 306 but on my old 405 all i had to do to get the rear of the fog lights was take out the wheel liner and then there was enough room for access. The screws holding in the light were on the front of the light so dead easy to take out and fiddle with.

hth

grattsim · Unread post by **grattsim** » 16 Aug 2007, 21:19

the lights are attached from behind the bumper.

Unread post by **CitroJim** » 16 Aug 2007, 23:38

grattsim wrote:the lights are attached from behind the bumper.

They are, but if you remove the arch liners it is just possible to remove them. You need a very long screwdriver though and a good helping of patience!

grattsim · Unread post by **grattsim** » 18 Aug 2007, 18:43

I'll have a try then, I must admit I'd like it to work without taking the bumper off. I just need enough sun to do the job.

If I do have to resort to having the bumper off, Do you know where the extra bolts are hidden?

Thanks

grattsim · Unread post by **grattsim** » 18 Aug 2007, 18:46

I'll have a try then, I must admit I'd like it to work without taking the bumper off. I just need enough sun to do the job.

If I do have to resort to having the bumper off, Do you know where the extra bolts are hidden?

Thanks