I've used the Lexia to reconfigure the new ECU, which came from a 1.6 engine to be suitable for my 2.2 engine and larger fuel tank.
However I can't find a way to copy "counter 1 and counter 2" values across. These are the amount of EOLYS in the FAP, and the amount of additive used from the additive tank. Help!
The Configuration screen offers four options:
- Additive top up or replacement
- Particle filter replacement
- Replacement of the additive ECU
- Configuration of the additive ECU
Using the third menu item, I get a screen that gives instructions: "If the ECU to be replaced is still communicating, copy the values of the two counters into the new ECU...". If I click the Vaidate key, then get a new screen titled "Replace additive ECU". It displays a single entry "Programming the total quantity of additive contained in the particle filter (counter 1)" with value "112". I need to change this to 14.
If I press Validate, I get a data entry screen, "Amount of additive = grammes" with value " 112".
I can type over the value, for example by changing it to "0000014" or " 14".
I then press Validate, and the display returns to "Programming the total quantity of additive contained in the particle filter (counter 1)", but this time with value "14".
However I can't find a way to save this new value. If I use Validate, it takes me back to the value-editing screen. If I press Configuration, it takes me back to the screen with the menu of four options - if I then go to look at the stored value, I find it's still at 112g.
Can anyone advise me how to set the counter 1 and counter 2 values, because I'm stuck?
In case it helps:
VIN: VF7**************[VIN obfuscated, can be read by forum staff],
Lexia 3, Pack: Expert, tool version 500.68,
Comms card: APPLI_X5_Fuji_P106138A, V4.3.3, @ACTIA 27.06.14,
Comms card software: V4.3.3
Mark