Xantia brake pipe union

[captainslow72]

Hi all I have a Xantia that has sat for few years when sorting out rear brake pads broke a pipe had new one made then other side failed. Trying to undo the union but it is stuck fast I have oiled it use mole grips ect still no movement I have now cut faulty brake pipe away and tried to undo the 4.5mm feed but that is also stuck. So before I go and get new k connector and feed pipe has anyone got any suggestions.

Thanks in advance

[c.morewood]

A little bit (or Maybe a lot ) of heat should loosen it.. the aluminium should expand faster than the union.
Good luck,
Chris

[captainslow72]

Thanks Chris will try that tomorrow.

[captainslow72]

Chris thanks again worked a treat and did need lots of heat ☺☺☺

[c.morewood]

Good ... Glad it worked