Difficulty of replacing a turbo?

This is the Forum for all your Peugeot Technical Questions, Problems or Advice.

Moderator: RichardW

Dave Burns
Posts: 1915
Joined: 14 May 2001, 05:30
Location: United Kingdom
My Cars:
x 2

Post by Dave Burns »

I've never seen any such kit on a Peug/Cit 1.9td, its possible that it might be from a 306 HDI, but I doubt it.
It would have to get its sample pressure from the manifold or anywhere on the intake tract thats subject to boost pressure, the original should get it directly from the compressor housing.
I don't think a load of numbers will mean much to anyone on here, you could try a turbo remanufacturing outfit for this purpose.
Dave
rossd
Posts: 420
Joined: 16 Mar 2001, 20:18
Location: United Kingdom
My Cars:

Post by rossd »

As Dave says, you could try a turbo remanufacturer or even garrett themselves with the code numbers. From the square manifold inlet and the 90 degree elbow on the end of the unit, it looks like it could be off a 306. Perhaps it was one of the later 1.9td's that had part electronic control, hence the fancy wastegate pipe outlets. The only other car I have seen with that arrangement was a petrol turbo, one was a boost inlet, the other a vacuum inlet. Never heard of a XUDT with a water cooled turbo though.
Ross
Post Reply