Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Tell us your ongoing tales and experiences with your French car here. Post pictures of your car here as well.
User avatar
MattBLancs
Donor 2024
Posts: 3622
Joined: 25 Apr 2022, 09:03
x 1729

Re: Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Unread post by MattBLancs »

RichardW wrote: 12 Mar 2024, 15:08 They either leak or the pressure drop is too high or too low - have a watch of some of O'Reilly's Autos vids on you tube, he's pretty scathing of them. And forced regens!
Ok thanks will have a look later :)
User avatar
MattBLancs
Donor 2024
Posts: 3622
Joined: 25 Apr 2022, 09:03
x 1729

Re: Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Unread post by MattBLancs »

Will update with the differential pressures shortly but all are low.

Just note down the sequence of menus:
Fault finding
Injection/ignition
Repair
Pack repair
After sales particular emission filter repair operation = no.
Replacement parts
Replacement of the particle emission filter

Warning: carry out this operation only after replacing the particle emission filter

Switch off the ignition
Switch on the ignition

Process done!

From the replacement parts menu also completed:
Filling of the diesel additive adding reservoir

Which part way through states:

Don't forget to do this in the additive ECU menu!

That will be what I did the weekend but didn't do this in the engine ECU menu!
User avatar
MattBLancs
Donor 2024
Posts: 3622
Joined: 25 Apr 2022, 09:03
x 1729

Re: Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Unread post by MattBLancs »

From the multiplexed additive ECU menu

Repair
Pack repair
Replacement parts
Fill additive tank

Message States complete this procedure in the engine ECU menu, clicking the tick it thinks for good while then pops up with the error message. I'm not sure if it is attempting to move me across from additive ECU menu to engine ECU menu?? Stops it anyway.
User avatar
MattBLancs
Donor 2024
Posts: 3622
Joined: 25 Apr 2022, 09:03
x 1729

Re: Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Unread post by MattBLancs »

From additive ECU, fault reading

Now States no faults found.

Back to engine ECU menu and the faults cleared.

Back to main menu and global test....
User avatar
MattBLancs
Donor 2024
Posts: 3622
Joined: 25 Apr 2022, 09:03
x 1729

Re: Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Unread post by MattBLancs »

No faults! Disconnecting the laptop, very quick test drive then off to bed!
User avatar
MattBLancs
Donor 2024
Posts: 3622
Joined: 25 Apr 2022, 09:03
x 1729

Re: Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Unread post by MattBLancs »

Quick drop of the print screens commentary to follow.

One fault remained on the radio ECU. Parameter measurement on the aerial page suggests something up there. Another day's job!

:-D
Attachments
A
A
B
B
C
C
D
D
E
E
F
F
G
G
H
H
I
I
J
J
K
K
User avatar
CitroJim
A very naughty boy
Posts: 52143
Joined: 30 Apr 2005, 23:33
x 7023

Re: Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Unread post by CitroJim »

That's looking better Matt :) Looks, on the face of it, like the radio can have two aerials... Is the radio fully functional?

Be good to see how the DPF behaves now over a period of time...
Jim

Runner, cyclist, duathlete, Citroen AX fan and the CCC Citroenian 'From A to Z' Columnist...
User avatar
MattBLancs
Donor 2024
Posts: 3622
Joined: 25 Apr 2022, 09:03
x 1729

Re: Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Unread post by MattBLancs »

CitroJim wrote: 13 Mar 2024, 05:56 That's looking better Matt :) Looks, on the face of it, like the radio can have two aerials... Is the radio fully functional?
I think it's one aerial/ external unit, but there's something like a signal amplifier involved - I remember reading something on the C5 stereo types and they have some with one connection, some with two. From memory it wasn't sat nav related, just radio. 308 SW could have built in sat nav, but despite being posh Allure spec, this doesn't have it.
Be good to see how the DPF behaves now over a period of time...
Yes, I'll keep this updated with performance updates good or bad.

Will try to remember to get some more DPF differential pressure readings in a few months, also see what the "average time between regens" figure changes too (hopefully a lot nearer what your C3's data shows)
User avatar
MattBLancs
Donor 2024
Posts: 3622
Joined: 25 Apr 2022, 09:03
x 1729

Re: Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Unread post by MattBLancs »

I'll seek "customer feedback" on the radio, as far as aware it works fine. Normally tuned to Classic FM, which is pretty feeble signal round here, I'll ask Sarah later if it's been notably worse in the 308 than other cars.
User avatar
MattBLancs
Donor 2024
Posts: 3622
Joined: 25 Apr 2022, 09:03
x 1729

Re: Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Unread post by MattBLancs »

MattBLancs wrote: 10 Mar 2024, 22:01 (Play with the laptop is instead to be tomorrow's job, after work)

Quick bit of research, I've gone for this set:
Image
£10.59 Inc delivery, includes 200 staples (split over 4 types) plus also side cutters, craft knife and box to keep it all together.

1200 staples seems to be about £8, so if device proves itself, will probably get through 200 quickly and that's not too bad to get a lifetime supply!

Few hairline cracks on the Coupe bumper (which they are prone to) but will do more out of sight structural repairs - like yesterday's splash guard - till I have got a feel for it.
Staplers has arrived, and even better than that...
Spoiler: show
it's come with a free plastic welding/stapling job to practice on!
Hoping the tool is more robust!
Hoping the tool is more robust!
:roll:
User avatar
CitroJim
A very naughty boy
Posts: 52143
Joined: 30 Apr 2005, 23:33
x 7023

Re: Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Unread post by CitroJim »

The box is broken deliberately Matt, it's your practice piece!
Jim

Runner, cyclist, duathlete, Citroen AX fan and the CCC Citroenian 'From A to Z' Columnist...
User avatar
bobins
Donor 2024
Posts: 6282
Joined: 05 Jul 2012, 18:07
x 3218

Re: Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Unread post by bobins »

Mine arrived a couple of days ago - you did better than me, Matt, as I don't even get an unbroken plastic box - I just get the carboard box it came in :bigcry: I can, however, say that it works rather well and as a bonus feature - the fuse is actually electrically wired in in the plug so it's less unsafe than a lot of the other imported tat available on ebay :lol: I have downrated it to a 3 amp though :wink:
User avatar
mickthemaverick
Donor 2024
Posts: 15487
Joined: 11 May 2019, 17:56
x 6626

Re: Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Unread post by mickthemaverick »

Mine arrived yesterday in the cardboard box but with a sculptured foam insert to hold the knife, cutters and staples. I haven't played with it yet but I'll report back later!! :)
I used to be indecisive, now I'm not so sure!
I used to ride on two wheels, but now I need all four!
User avatar
bobins
Donor 2024
Posts: 6282
Joined: 05 Jul 2012, 18:07
x 3218

Re: Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Unread post by bobins »

They supplied the wrong cutters in mine, Mick. Mine are the ones designed to cut wet spaghetti so they've got no hope cutting the staples :roll:
User avatar
mickthemaverick
Donor 2024
Posts: 15487
Joined: 11 May 2019, 17:56
x 6626

Re: Suspension sinks on Sundays! C5 X7 that works hard + 206 GTi HDi (and 406 Coupe and 306 HDi). - MattBLancs

Unread post by mickthemaverick »

I'd assumed they were supplied to cut the cable ties you use to hold it together while stapling, as long as you only use the excruciatingly thin ones that you can bite through if you need to!! :-D
I used to be indecisive, now I'm not so sure!
I used to ride on two wheels, but now I need all four!