ZX rear brakes job

Post by **RichardW** » 19 May 2010, 21:08

You should be able to get the cylinders from GSF or any motor factors, now you know which ones you need! GSF used to stock the adjuster kit.

citronut · Post by **citronut** » 20 May 2010, 08:06

RichardW wrote
"GSF used to stock the adjuster kit"

they didnt used to stock the BENDIX adjuster kits,

regards malcolm

Post by **RichardW** » 20 May 2010, 09:03

I can't remeber which is which - mine had the rod with threaded adjuster on the end and the L shaped stainless ratchet (which always gets lost!) which I was able to buy from GSF (wasn't cheap though, as I only wanted the L shaped bit

KEB1 · Post by **KEB1** » 25 May 2010, 15:10

Just a further query. Has anyone fitted the Quinton Hazel BS777 kit to their ZX (substitute for Lucus Girling) ?
Unfortunately, my kit should have been supplied with two internal "star" washers (for want of a better word) that fit under the adjuster blade but they were missing. I phoned QH and they kindly sent me replacements but they are not a tight fit on the scroll pin as they are on the old shoes. This might not matter but I would like conformation before I fit them as, after all, they are as important as everything else in there.
Anyone any thoughts ?

Kristian.

the_weaver · Post by **the_weaver** » 27 May 2010, 20:34

I got two star washers with my new brake shoes. One of the star washers was a loose fit and it ended up getting lost.

Paul