Ax Balljoint Fitting

Darren · Post by **Darren** » 19 Mar 2001, 00:21

What is the correct way to fit the front lower balljoint to an ax ? I managed to remove the old one ,But I'm having trouble tring to fit the new one ,any advice most welcome
Thanks

paulivil · Post by **paulivil** » 24 Mar 2001, 10:50

<font face='Georgia'>I think you will need a press for that job. How on earth did you manage to remove the old one without one?</font id='Georgia'>

jloner2 · Post by **jloner2** » 24 Mar 2001, 15:05

take off the wish bone,get a vise, find a pipe the size of the joint and just hammer it until its home.....