106 Rear Hub Nut Thread

This is the Forum for all your Peugeot Technical Questions, Problems or Advice.

Moderator: RichardW

Post Reply
caspar
Posts: 24
Joined: 22 May 2002, 17:46
Location: West Sussex
My Cars:

106 Rear Hub Nut Thread

Post by caspar »

I was replacing a rear wheel bearing on my 1998 106 1.1 and discovered the thread holding the hub on was quite badly damaged. Someone told me that the thread is splined in from the back and can be replaced with a new one. Is this the case? The Haynes doesn't mention this.
Thanks.
Top
addo
Sara Watson's Stalker
Posts: 7098
Joined: 19 Aug 2008, 12:38
Location: NEW South Wales, Australia. I'll show you "Far, far away" ;-)
My Cars: Peugeot 605
Citroën Berlingo
Alfa 147
x 93

Post by addo »

Peugeot don't list it as a separate part, however it may be that you can remove the arm and swap the stub axle portion - it'd take a good sized press to achieve though.

Given the vehicle age, possibly swapping the entire arm for a recycled unit is the easiest option.
Top
User avatar
Oldpug
Posts: 482
Joined: 07 Aug 2010, 11:15
Location: Berkshire
My Cars: Peugeot 406 GLX
Audi A3 TFSI S Line
Mercedes SL320
(In the past,just about every old Peugeot you can think of.)
x 64

Post by Oldpug »

Rear stub axle pins are available from Euro car parts or GSF car parts.Just hammer the pin out (with a very big hammer!) and same in reverse,15 min job!There are lots of different lengths so make sure you get the correct one.
Top
Post Reply

Return to “Peugeot”