The button on my key has fallen off (outer part that covers the switch) as shown below:
The key still works but I'm sure that it will be collecting pocket lint and dust soon. Not wanting to go to the expense of a whole new key, I've decided to just swap the plastic bit on the outside, but upon opening the case I can't see how to remove the metal part (the key) to put it into the replacement (probably bought cheap from fleabay)
Any ideas?
Cheers
Pete
406 Key question
Moderator: RichardW
406 Key question
French car free zone....
-
- Posts: 288
- Joined: 27 Feb 2005, 21:05
- Location: Telford.
- My Cars:
- x 3
Hi,
I had the same problem with the key on my old 306.
I purchased a replacement case off Ebay and swapped it over.
To change it undo the screw in the key (as if replacing the batterys) and the inner parts come out easily and the metal key blade slides out too.
I had the same problem with the key on my old 306.
I purchased a replacement case off Ebay and swapped it over.
To change it undo the screw in the key (as if replacing the batterys) and the inner parts come out easily and the metal key blade slides out too.
R Reg Phase 2 306 DTurbo (Blaze Yellow) (Sold)
X Reg Phase 3 306 1.4 LX (Sold)
03 Renault Scenic Dynamique +
03 Seat Leon 1.9 TDi
52 Nissan Almera 1.8 sport+
X Reg Phase 3 306 1.4 LX (Sold)
03 Renault Scenic Dynamique +
03 Seat Leon 1.9 TDi
52 Nissan Almera 1.8 sport+