206 Main/Dipped beam relay

This is the Forum for all your Peugeot Technical Questions, Problems or Advice.

Moderator: RichardW

Post Reply
TroutWrestler
Posts: 1
Joined: 24 Nov 2005, 15:41
Location:
My Cars:

206 Main/Dipped beam relay

Post by TroutWrestler »

Hi all,
I've just bought a 2003 206 SW. I find the fact that the dipped beam goes out when the main headlights are switched on really annoying. Is rectifying this just a case of removing/bypassing a relay? And if so, which one?

Cheers, Charlie
PowerLee
Posts: 1260
Joined: 01 May 2004, 19:49
Location: United Kingdom
My Cars: Current - Slightly modified 2016 Pug 308 Puretech 130 Allure
Past:
2003 - 206 GLX TU3JP & 206 SE ET3JP4
1995 - 405 Executive XU10J2
1996 - 406 GLX XU10J4R
1994 - 405 GTX XU10J2
x 1

Post by PowerLee »

Hi

A 2003 Pug 206 is gonna be multiplexed, Never EVER start bypassing relays & messing around with the wiring or trying to add things to the wiring, You can cause a whole load of EXPENSIVE damage to your car!

Do you have the H4 or H7 headlamp set up? Have a look on top of the headlights on the black plastic part, It will say H4 or H7 on them & post back.

Are the lights really going out or is it the slight delay you have noticed when you switch between dip & main?

Multiplex is Peugeots digital wiring system, If you start messing about it will end in expensive tears! I would ask the local dealer about getting the lastest software downloads for your car :wink:

Anyway a 2003 206 is still under Peugeot warranty, Make the most of it while you can :wink:
Post Reply