What message are you getting? On my car it was something along the lines of "LH front tyre not being monitored" and this was fixed by replacing the valve sender.
Have you tried pressing the "Check" button on the lower RH side of the dash (next to the "Off" and ">P<" buttons)? This should give a readout of the tyre pressure status on the instrument panel screen.
C5 X7 tyre pressure monitoring
Moderator: RichardW
- Paul-R
- Donor 2023
- Posts: 6916
- Joined: 07 May 2009, 16:24
- Location: Wirral, NW England; Vaucluse 84, France
- Lexia Available: Yes
- My Cars: 2015 1.6 Blue HDi 120 Peugeot 308 Active SW
2013 2.0 HDi 163 C5 Exclusive Tourer
2003 2.0 HDi 110 C5 Exclusive Estate (Gone)
2001 2.0 HDi 90 Xsara Estate (Gone) - x 1369
Re: C5 X7 tyre pressure monitoring
As I get older I think a lot about the hereafter - I go into a room and then wonder what I'm here after.
Inside every old person is a young person wondering what the hell happened.
"Trying is the first step towards failure" ~ Homer J Simpson
Inside every old person is a young person wondering what the hell happened.
"Trying is the first step towards failure" ~ Homer J Simpson
-
- Posts: 133
- Joined: 01 Jan 2016, 13:54
- Location: Oxford
- My Cars: Citroen C5 Tourer 2013 2.2 HDI
Caterham 21 ( for fun)
Re: C5 X7 tyre pressure monitoring
I had a few issue with the TPMS recently.
What needs to be done if you get new sensor:
1) write down the sensor ID number for each wheel and location on the car
2) Fit wheel to the car
3) with diagbox set the ID number on correction location
4) job done
My local mechanic did that and it worked, he has a multi brand diagnostic computer tool thing
if you are locale to me (oxford) I may able to help set them if you have the ID numbers
Jack
What needs to be done if you get new sensor:
1) write down the sensor ID number for each wheel and location on the car
2) Fit wheel to the car
3) with diagbox set the ID number on correction location
4) job done
My local mechanic did that and it worked, he has a multi brand diagnostic computer tool thing
if you are locale to me (oxford) I may able to help set them if you have the ID numbers
Jack