C5 Spheres

This is the Forum for all your Citroen Technical Questions, Problems or Advice.

Moderator: RichardW

Post Reply
lexi
(Donor 2020)
Posts: 2803
Joined: 17 Apr 2008, 17:51
Location: Scotland
My Cars:
x 138

C5 Spheres

Post by lexi »

Guys; These genuine NOS spheres that lie around dealers? Are they good as new? I mean, do the C5 units loose pressure like the old type with old father time? Also, the genuine units are better?
Citroen C5 1.6 HDI 110bhp Estate 06 plate

French Mistresses gone.
Citroen C5 HDI Mk 1 hatchback
Vel Satis 3.5 v6
ZX 1.9D Est.
ZX 1.9DHatch
Xantia 1.9td est.
Xantia 2.0 hdi Est.
Xantia V6 MK1
Xantia V6 MK 2
Peter.N.
Moderating Team
Posts: 11574
Joined: 02 Apr 2005, 16:11
Location: Charmouth,Dorset
My Cars: Currently:

C5 X7 VTR + Satnav Hdi estate Silver
C5 X7 VTR + Hdi Estate 2008 Red

In the past: 3, CX td Safaris and about 7, XM td estates. Lovely cars.
x 1204

Re: C5 Spheres

Post by Peter.N. »

The later type spheres seem to be better, I fitted new ones to mine about 4 years ago and there has been no noticeable deterioration and they should last longer if not being used. Mine were non genuine ones but the suspension goes up and down OK. Doesn't ride as well as the XM though, never did.

Peter
lexi
(Donor 2020)
Posts: 2803
Joined: 17 Apr 2008, 17:51
Location: Scotland
My Cars:
x 138

Re: C5 Spheres

Post by lexi »

Thanks Peter. I don't expect new spheres to transform it, although the originals at 13yr old must have lost pressure.
The old ones are ghastly to look at!
Citroen C5 1.6 HDI 110bhp Estate 06 plate

French Mistresses gone.
Citroen C5 HDI Mk 1 hatchback
Vel Satis 3.5 v6
ZX 1.9D Est.
ZX 1.9DHatch
Xantia 1.9td est.
Xantia 2.0 hdi Est.
Xantia V6 MK1
Xantia V6 MK 2
Peter.N.
Moderating Team
Posts: 11574
Joined: 02 Apr 2005, 16:11
Location: Charmouth,Dorset
My Cars: Currently:

C5 X7 VTR + Satnav Hdi estate Silver
C5 X7 VTR + Hdi Estate 2008 Red

In the past: 3, CX td Safaris and about 7, XM td estates. Lovely cars.
x 1204

Re: C5 Spheres

Post by Peter.N. »

The easiest way to test them is to bounce each corner, if they are in good order you should get about 4-6" of movement on the back and 2-4" on the front. After I changed mine the back still wouldn't go up and down easily, the radius arm bearings had seized, once I had changed them it was OK - so I may not have needed spheres although the car had done about 180k miles so probably did.

Peter
Post Reply