RE: RELAY HDI 2.2 POWER STEERING

[cozypillow]

Hello, I have a Relay 08 HDI 2.2 120Bhp Van and can anyone tell me how to fit a new union & seal to the high pressure power steering pipe at the pump end? I have the new pipe and have ordered the union and seal, as they allegedly come separately, from my local Citroen Dealer, but I have asked this question with the dealer but they have not returned my calls?

The original union had a copper olive and rubber seal inside and a plastic seal around the base of the union threads. I also imagine that there must have been a rubber seal at the top of the flared end of the pipe that fits into the pump itself? I am unsure of how the new union can fit to the flared end of the pipe? I am guessing that there may be a special tool?

Because I have not seen the new union I am unable to guess how they fit together without the use of sequential method or tool?

Can anyone help?

Regards,

[cozypillow]

Anyone any ideas?

[Hell Razor5543]

Somebody with Relay or piping knowledge will get back to you on this. The delay is because they haven't yet read this post. If I could help I would. You are not being ignored.