Xantia fans

This is the Forum for all your Citroen Technical Questions, Problems or Advice.

Moderator: RichardW

Post Reply
User avatar
froggy
Donor 2023
Posts: 640
Joined: 05 Jul 2010, 20:24
Location: too far from citrojim"s
My Cars: S2 Xantia Forte 185435.
Peugeot 306 Meridian, the boss.
x 2

Xantia fans

Post by froggy »

Hi, Just changed the coolant in my Fathers 1997 Xantia , T,D, The fans are not cutting in, with the temp gauge at 100. My Father isn"t sure if they were working before the coolant change . Could the coolant change be responsible for the fans not working? any advice greatfully received . cheers Terry.
Terry
Xantia TD lx series1 SORN
Peugeot 306 meridian [ the boss]
Xantia HDI Forte 1997 CC
User avatar
DickieG
Monaco's youngest playboy
Posts: 4877
Joined: 25 Nov 2006, 09:15
Location: Buckinghamshire
My Cars:
x 38

Re: Xantia fans

Post by DickieG »

Well you could obviously have an air lock but it could be a problem with the cooling fans, a quick easy check you can do on the fans if the car has A/C is to turn it on and see whether the fans run.
13 Ram 1500 Hemi
14 BMW 535D Tourer
19 BMW i3s
06 C3 Desire 1.4
72 DS 21 EFi Pallas BVH
wotwot
(Donor 2021)
Posts: 307
Joined: 13 Jul 2010, 08:59
Location: chelmsford, essex.
My Cars: 1982 GSA 1299
1984 bx 1600
zx 5 door x 2
xantia estate
dispatch
xara picasso
806
807 SE
x 4

Re: Xantia fans

Post by wotwot »

As DickieG says could be an airlock but maybe worth disconnecting the fan plugs and do a direct feed from the battery to see if they are working and go from there.
User avatar
froggy
Donor 2023
Posts: 640
Joined: 05 Jul 2010, 20:24
Location: too far from citrojim"s
My Cars: S2 Xantia Forte 185435.
Peugeot 306 Meridian, the boss.
x 2

Re: Xantia fans

Post by froggy »

Thanks guys. How do I clear any air in the system? Is it a case of; undoing the bleed cap and top up the system again ? cheers Terry. :oops:
Terry
Xantia TD lx series1 SORN
Peugeot 306 meridian [ the boss]
Xantia HDI Forte 1997 CC
User avatar
DickieG
Monaco's youngest playboy
Posts: 4877
Joined: 25 Nov 2006, 09:15
Location: Buckinghamshire
My Cars:
x 38

Re: Xantia fans

Post by DickieG »

froggy wrote:Thanks guys. How do I clear any air in the system? Is it a case of; undoing the bleed cap and top up the system again ? cheers Terry. :oops:
Ideally you need to make up a header tank (an upturned squash bottle usually does the job) then run the engine whilst squeezing the top hose to push air out of the system. Are the fans working?
13 Ram 1500 Hemi
14 BMW 535D Tourer
19 BMW i3s
06 C3 Desire 1.4
72 DS 21 EFi Pallas BVH
User avatar
froggy
Donor 2023
Posts: 640
Joined: 05 Jul 2010, 20:24
Location: too far from citrojim"s
My Cars: S2 Xantia Forte 185435.
Peugeot 306 Meridian, the boss.
x 2

Re: Xantia fans

Post by froggy »

no, they are not working, cheers Terry .
Terry
Xantia TD lx series1 SORN
Peugeot 306 meridian [ the boss]
Xantia HDI Forte 1997 CC
citroenxm
Posts: 8061
Joined: 30 Dec 2004, 23:10
Location: Somewhere in North Wales, Anglesey
My Cars: M reg Xm S2 2.1td Auto Exclusive. 269k and rising
L reg XM S1 V6 12v Manual SEi
L 94 XM 2.1 TD auto total resto

2008 Peugeot 207 Sw 1.6 16v hdi. 217k and rising
2010 Peugeot 207 SW 1.6 8v HDi 161k and rising
x 71

Re: Xantia fans

Post by citroenxm »

This sounds like the Common 3 Relay layout failure...

There are three relays between the fans behind the grill, hidden in a triangular box.. these control the fan speeds with signals from the Coolant ECU.. Its VERY common for the terminals to corrode and then arch and over heat and loose connection!

Remove your grill, then remove the top cover from the triangular box and remove each relay.. Id be sure you'll find a didgy connection in there... IF not then it could also be typical french wires and a break has occured in the harness behind the passenger headlight..

I find that for clearing air, open the Heater Matrix bleed screw and get the hot water flowing through the heater.. then go for a SHORT drive with the expansion cap loose, this then helps get all air out, and has worked every time for me.. Top up and tighten the cap..

Paul
Sharing a pug 207 1.6 hdi Sw 16v.
M reg Xm 2.1 td auto exclusive S2 269k and rising
L reg XM V6 12v SEi auto .. Light project

A very sad...
1994 XM 2.1 d auto
Post Reply