saxo hub nut

imperial21 · Post by **imperial21** » 23 Jun 2011, 22:47

Hi
Does anyone know the size for a saxo mk1 1.1 hub nut ?

citronut · Post by **citronut** » 24 Jun 2011, 07:34

i think its either 32 or 34mm, and its peened into indents on the drive shaft stub,

they do recomend you fit new every time they are removed,

i find quite often you can switch left and right from one side to the other the first time off,

and if your a real skin flint you can file the mateing surface down a touch, as this allows you to wind it a little, so you have unused metal to peen over,

regards malcolm

spider · Post by **spider** » 24 Jun 2011, 09:49

It is recommended to replace them, dealers always will (or should) , but as above you can swap them if you wanted to as the peening will be in a different place. Obviously only works once.

Chris570 · Post by **Chris570** » 24 Jun 2011, 10:54

Sorry its a 30mm for the front and a 32mm for the back.

imperial21 · Post by **imperial21** » 24 Jun 2011, 18:39

Hi all
Thanks for your answers, chris570 you are right 30mm on the front !

citronut · Post by **citronut** » 24 Jun 2011, 19:41

i knew it began with a 3

when i do these i have two sockets one under the other in the top of my tool box which i grab both, without looking what size im useing,

the second one must be 32mm then,

regards malcolm