Hi all,
Having got an advisory on the front brake balance for the ZX at the last MOT, I decided to tackle the problem today - day off - no rain!
The bottom sliding pin had siezed on the N/S, so I cleaned it all up and re-asembled with copper grease.
I decided to check the O/S and the bottom pin was partially siezed, so sorted that as above.
The bottom one suffers most in the line of duty, but I did notice a couple of small splits in the rubber boot on the N/S one though.
The pistons move freely both sides
Is it possible to buy these and the pins separately?
It's a Girling setup by the way.
Cheers
ZX brake balance sorted - day off well spent
Moderator: RichardW