Does anyone have any info re correct alignment of the rear 'P' Bush in the Wishbone
on my Pug 405?
The BoL offers me this rather laughably inadequate illustration, Chapter 10.6 of Haynes 3198, 405 Diesel
Wishbone 'P' Bush Alignment
Moderator: RichardW
- Pug_XUD_KeenAmateur
- (Donor 2018)
- Posts: 1168
- Joined: 22 Apr 2013, 17:24
- Location: South Midlands / M4 / M5
- My Cars: 405 naD Est
- x 232
-
- Posts: 251
- Joined: 04 Oct 2018, 14:26
- Location: mid wales
- My Cars: pug306, citroen picasso
- x 14
Re: Wishbone 'P' Bush Alignment
On our 306 we saw some alignment lines, where did you get the p bush from??
set the bush so it will align with the mounting frame when the wishbone is in the natural position, which may be more or less horizontal, when the car is on its wheels, if that hepls.
it should be pressed onto the wishbone stub and the centre steel tube should not rotate on the wishbone pin.
you will need a g clamp for aid when refitting the wishbone, but make sure the anti roll bar clamp is in place properly, on a 306 anyways.
set the bush so it will align with the mounting frame when the wishbone is in the natural position, which may be more or less horizontal, when the car is on its wheels, if that hepls.
it should be pressed onto the wishbone stub and the centre steel tube should not rotate on the wishbone pin.
you will need a g clamp for aid when refitting the wishbone, but make sure the anti roll bar clamp is in place properly, on a 306 anyways.
- Pug_XUD_KeenAmateur
- (Donor 2018)
- Posts: 1168
- Joined: 22 Apr 2013, 17:24
- Location: South Midlands / M4 / M5
- My Cars: 405 naD Est
- x 232
Re: Wishbone 'P' Bush Alignment
Thanks Picasso, no alignment marks in this case (forget where it was bought from as from my spares) Anti-Roll Bar is different on the 405, but aware that on the 306 its bolted to the wishbone
Appreciate the trouble.
Appreciate the trouble.
Puxa